Flymo Garden Vac How to Use Con’t, Emptying your Gardenvac, Caring for your Gardenvac, Jet Vacuum

How to Use Con’t

JET VACUUM

N

Position 3 - Jet Vacuum Mode This position is intended to be used to collect debris which is damp or stubborn. It directs a small jet of air towards the ground which will loosen stubborn material.

Using As A Jet Vacuum

1.Select position 3 on the mode indicator. See fig N.

2.Position the nozzle above and slightly forward of the debris and squeeze the trigger.

3.Slowly move the nozzle back over the debris. This allows a jet of air to lift the debris from the ground.

4.To stop release the trigger.

Emptying your Gardenvac

P ✔

✕

• Switch off and disconnect from the mains electricity supply BEFORE REMOVING OR REPLACING the fully assembled debris bag.

Emptying Your Gardenvac

1.Remove debris bag as described on page 4.

2.Empty debris bag holding the moulded handle at

the top of the bag and the fabric handle at the bottom of the bag. (P)

DO NOT PLACE HANDS IN BAG WHEN EMPTYING, SHARP DEBRIS CAN CAUSE INJURY

3.Flip the debris fin back into place before re-fitting as described on page 3.

Caring for your Gardenvac

Q1	Q2
Q3	Q4
Q5	Q5

WARNING Never use water for cleaning your product, use only a dry cloth. Do not clean with chemicals or solvents, some can destroy critical plastic parts. After Using Your Gardenvac (Q1, 2, 3 & 4)

1.Switch off and disconnect from the mains electrici- ty supply before cleaning your product.

2.Always empty the debris bag.

3.Take extra care to clean around the cutting head

and the collection chute.(Q1)

•Take care when cleaning around the cutting line area - sharp edges can cause injury.

4.Inspect the cutting line and replace if worn or damaged

5.Using a soft brush remove debris from all air inlets. (Q2)

6.Remove dirt and debris from debris fin.with a suit- able tool. (Q3)

7.Wipe over your product with a soft dry cloth. (Q4)

Replacing the Cutting Line (Q5 & 6)

• Switch off and disconnect from the mains elec- tricity supply before replacing the cutting line

• Handle the cutting line with care - sharp edges can cause injury.

1.Remove debris bag from product. See Page 4.

2.Remove cutting line (Q5) and discard safely.

3.If the cutting line becomes broken during use -

use a suitable tool to lever the line out of location.

(Q6).

4.Place the cutting line into the slot in the cutting

head. Ensure the cutting line is correctly located.

See Page 3.

5.Re-fit debris bag to product. See Page 3.

Storing Your Gardenvac

Always store the product in a dry place ensuring the cable is not likely to be damaged on sharp edges etc.