Caring for your Product
Cleaning (T) | T | |
| ||
• | USE GLOVES |
|
| ||
• | IMPORTANT |
|
It is very important that you keep your product clean. Grass clippings left in any of the air intakes or under the deck could become a potential fire hazard.
1. Remove grass from under the deck with a brush.
2. Using a soft brush - remove grass clippings from all air intakes, the collection box and the vision window
3. Wipe over the surface of your product with a dry cloth.
• IMPORTANT
Never use water for cleaning your product. Do not clean with chemicals, including petrol, or solvents - some can destroy critical plastic parts.
At the End of the cutting Season
1. Replace tines, bolts, nuts or screws, if necessary.
2.Clean your product thoroughly.
3. Make sure that the electric cable is coiled properly.
Storing your product: Store in a dry place where your product is protected from damage
Fault Finding Hints
Fails to Operate
1.Is the correct Starting procedure being followed? See ‘To Start your Lawnrake’
2.Is the Power Turned On?
3.Check the fuse in the plug, if blown replace.
4.Fuse continues to blow?
Immediately disconnect from the mains electricity supply and consult your local approved Service Centre.
Poor Collection
1.Disconnect from the mains electricity supply.
2.Clean the outside of the air intakes, the discharge chute and the underside of the deck.
3.Try a different height of rake. See ‘Height Adjustment’.
4.Check condition of the Tines and replace if necessary. See ‘Removing and Fitting the Tines’.
5.If poor collection persists.
Immediately disconnect from the mains electricity supply and consult your local approved Service Centre.
Excessive Vibration
1.Disconnect from the mains electricity supply.
2.Check that the tines are functioning correctly.
3.Replace tines if necessary
4.If vibration persists?
Immediately disconnect from the mains electricity supply and consult your local approved Service
Centre.
Lawnrake becomes heavy to push
1.Disconnect from the mains electricity supply.
2.In long grass or uneven ground, the height of cut should be raised to a higher position. See Cutting Height Adjustment.
3.Check that the wheels can rotate freely.
4.If problem persists?
Immediately disconnect from the mains electricity supply and consult your local approved Service Centre.
Service Recommendations
1.We strongly recommend that your product is serviced at least every twelve months, more often in a profes- sional application.
2.Always use genuine Spare Parts.
3.Prepacked spares are available from most Husqvarna Outdoor Products stockists and www.flymo.com.
4.Your product is uniquely identified by a silver and black product rating label
5.If you have a problem with your machine contact your local Approved Service Centre ensuring you have full details of your product as described on the product rat- ing label.
6.Should it be necessary for work to be carried out by your Service Centre, it is important to take your complete
machine including cable and any extension cables used.
A network of specialist dealers can be found in your local Yellow Pages.
To obtain service on your product simply telephone or visit your local Service Centre.
Should you require service under the terms of our guarantee the Service Centre will require proof of purchase.
All of the centres listed stock genuine Spare Parts.
NOTE: Our Service Repairers act on their own behalf and are not empowered to commit or legally bind Husqvarna Outdoor Products in any manner whatsoever.
Environmental Information
Husqvarna Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life.
•Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.
•Awareness of the environment must be considered when disposing of
•If necessary, contact your local authority for disposal information.
