Flymo Sabre Power Pack Fitting the Battery Charger and Charging the Power Pack, Carton Contents

Models: Sabre Power Pack

1 2
Download 2 pages 11.91 Kb
Page 2
Image 2

Carton Contents

Fitting the Battery Charger and Charging the Power Pack

Sabre Handle

Sabre storage holder

Handle

Power Pack

screws x 4

Power Pack

charger

instruction

screws x 4

 

manual

Power Pack

 

 

 

charger bracket

IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product.

IF ANY PARTS ARE MISSING CONTACT:-

Husqvarna Outdoor Products Customer Service Department direct

Telephone : 01325 300303, Fax : 01325 318193

Safety

If not used properly this product can be dangerous! This product can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product. The operator is responsible for following the warning and safety instructions in this manual and on the product.

Explanation of Symbols on your product

 

 

Read the user instructions carefully to

Warning

 

make sure you understand all the con-

 

trols and what they do.

 

 

1. Always charge the Power Pack indoors and store in

7.

Do not use the charger outdoors.

a cool dry place - out of the reach of children.

8.

Do not charge the Power Pack or use the unit in an

A

1

B

1

Attach the Power Pack charger bracket to the wall using the four screws provided (A)

IMPORTANT !

Switch charger off at the socket before connecting or disconnecting the Power Pack to the charger bracket

Initial Charging Procedure

The Power Pack should be charged for 24 hours before use.

Re-charge your Power Pack immediately after every use for the full 24 hour charging period.

The Power Pack can be left connected to the charger permanently, with the charger switched on, without fear of overcharging.

The charger will automatically keep the Power Pack topped up with charge during storage and will ensure that the Power Pack is ready for use.

1.Use the charger indoors only.

2.Ensure the charger is not exposed to moisture. Keep the charger and Power Pack dry at all times. Keep the charger well ventilated during charging.

3.Ensure the Power Pack is correctly located into the bracket (B) and the charge connector (A1).

4.Plug the charger into a suitable household electrical socket and switch on.(B1)

5.The indicator lamp glows continuously during charging.

6.Full charge will be achieved in 24 hours. During charging the charger becomes warm. This is normal

and means the charger is operating correctly.

Re-Charging Your Power Pack

1.Re-charge the Power Pack as soon as the cutting power of your product begins to die and slow down.

2.Avoid running the cordless product into "deep" discharge, i.e. avoid flattening the Power Pack completely.

3.Follow the procedure outlined in the Initial Charging

Procedure.

4.Charging the Power Pack according to these instructions should ensure maximum battery life.

2.

Use only the charger provided with your unit. Use of

explosive or corrosive environment. Avoid areas

 

any other charger could permanently damage the

where flammable liquids or gases are present to

 

Power Pack.

avoid creating a fire or explosion.

3.

Use the charger with standard domestic household

9. Do not attempt to repair the unit including the Power Pack.

 

electrical outlets only.

10.Do not incinerate or mutilate the Power Pack.

4.

Do not abuse the charger or charger cord.

Batteries contain hazardous chemicals. Dispose of

5.

Do not use the charger if the charger or charger

properly.

 

cord is damaged.

 

6.

Use the charger indoors only.

 

Power Pack

Storing the Sabre Handle

Storing the Sabre Handle

1.Attach the Sabre Handle Storage Holder to the wall with the two screws provided (C)

2.Store the Sabre Handle in the holder as illustrated in Fig D

Power Pack Care

1. If over a period of time the Power Pack quickly runs

down after a full 24 hour charging period, a

replacement Power Pack is needed.

Power Pack Replacement

Your Power Pack is non-servicable. Should your Power Pack need to be replaced contact your local approved service centre or dealer who will replace your old Power

Environmental Information

2.

There will be some charge present in the Power

 

Pack but to ensure maximum running time, recharge

 

your Power Pack for 24 hours before use.

3.

Permanent connection to the charger in a well

 

ventilated area will automatically keep your Power

 

Pack fully charged ready for use.

4.

To prevent permanent Power Pack damage, never

 

store in a discharged condition.

5.

Contact your local approved service

 

centre/dealer/distributor for a replacement Power

 

Pack and for safe disposal of your old Power Pack.

6.

Battery

24 Volt 4.5 Amp/Hour

"High Power"

Sealed for Life

No maintenance required

IMPORTANT

DISPOSE OF YOUR OLD POWER PACK SAFELY DO NOT CUT OPEN, BURN OR INCINERATE.

Pack with a genuine Flymo replacement Power Pack.

Winter Storage

1.Fully charge for 24 hours before winter storage.

2.If you are unable to leave your Power Pack on per- manent charge, re-charge the Power Pack every 3 to 4 months for a full 24 hour charging period to top up the Power Pack charge during winter storage.

3.Avoid extended storage without re-charge.

4.Store in a cool dry place.

For further information on Power Pack replacement contact Husqvarna Outdoor Products Customer Service direct:-

Telephone :

01325 300303

Fax

:

01325 318193

Husqvarna Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to com- pany procedures, and with the potential for recycling at the end of the products’ life.

Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.

Awareness of the environment must be considered when disposing of ‘end-of-life’ product.

If necessary, contact your local authority for disposal

information.

BATTERY DISPOSAL

The battery should be taken to an Approved Service Centre or your local Recycling Station.

Do NOT dispose of used battery with household waste

Do NOT dispose of battery to water.

Lead/Acid batteries can be harmful and should be dis-

posed of through the recognised recycling facility in accordance with European Regulation

• Do NOT incinerate

The symbol on the product or on its packaging indicates that this product may not be treated as house- hold waste. Instead it shall be handed over to the appli- cable collection point for the recycling of electrical and electronic equipment.

By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the envi- ronment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council office, your household waste disposal service or the shop where you purchased the product.

Page 2
Image 2
Flymo Sabre Power Pack manual Fitting the Battery Charger and Charging the Power Pack, Power Pack Storing the Sabre Handle