BRICK INSTALLATION
IMPORTANT: Installation of brick should be done before wood nook is placed in a permanent location. Top panel and front face must be removed prior to installing bricks (see Figure 2). Bricks are packaged in three separate boxes. These boxes are labeled by sections of firebox.
Box # 1 - Left and Right Panel
Box # 2 - Bottom Panel
Box # 5 - Rear Panel
Box # 1 - Left and Right Panel
Box # 3 - Bottom Panel
Box # 6 - Rear Panel
Box # 1 - Left and Right Panel
Box # 4 - Bottom Panel
Box # 7 - Rear Panel
Top Panel
Each brick housing is stamped with a letter (full size bricks are not stamped). These will help identify brick when installing. It is important to install these bricks exactly as instructed.
Install bricks one section at a time starting with hearth (bottom) panel followed by rear panel and lastly sides panel (see Figure 3, Figure 4, page 4, or Figure 5, page 5, depending on your model). It is important to install bricks in this sequence.
Press Brick firmly into brick housing until it snaps. Groove line on side of brick will come in contact with flange on brick housing. This secures brick into housing (see Figure 3).
Brick | Stamped Letter |
| Location |
| Flanges |
Brick
Housing
Front Face
Figure 2 - Panel and Front Face Removalwww.fmiproducts.com | 3 |