| OPERATION |
|
|
| Continued |
|
|
|
| NMAI | |
| IN |
|
|
| PILO | PILOJTAD | T |
Incoming |
| TOU |
|
|
|
| |
Gas Line | Equipment |
|
|
| Shutoff Valve |
|
|
Figure 25 - Turning Equipment Shutoff Valve to the OFF
Position
gas control module System
remote control feature
The module has a built in remote control receiver that allows the user to program the remote transmitter at any time during or after the installation of the burner.
1.There is a switch located on the right side of the module that reads REMOTE/OFF (Figure 26).
2.When the remote/off switch is in the OFF position, the burner will operate from the rocker switch or wall switch connected to the two BROWN wires on the module.
3.When the remote/off is in the REMOTE position the burner will operate from the Remote Control transmitter.
NOTE: The module must be programmed to the Remote Control transmitter.
Inspecting Burners
Check burner flame patterns often.
IGNITOR assembly
The ignitor assembly is factory preset for proper ignition of the burner. Alterations may have occurred during shipping and handling. Call a qualified service person to readjust the ignitor assembly if necessary.
The ignitor should be positioned as shown in Figure 28.
Note: Figure 28, shows the correct positioning of the ignitor and sensing rod.
If your ignitor assembly does not meet these requirements:
•turn appliance off (see To Turn Off Gas to Appliance, page 14).
•see Troubleshooting, page 18
Sensing Rod
Ignitor
• To program the module (make sure the system has power), |
locate the learn button (Figure 27) on the module. Locate |
the metal shield that is covering the module and remove |
the screw on top. Use a small thin object like a paper clip |
(not sharp points) to press and release the learn button. |
There will be a beep sound from the module. Then press |
Burner
Tube
Ignitor
any button on the remote transmitter. Once the module's |
internal receiver accepts the transmitter code, there will |
be a series of confirming beeps. |
• The remote system is ready for use. |
Remote/Off Switch | ADJ. |
“S” Pilot Connection | “I” Pilot Connection |
Figure 26 - Gas Module Right Side | |
Learn Button | AUX Connection |
Figure 28 - Ignitor Assembly
Burner Flame Pattern
Figure 29 shows correct burner flame pattern.
NOTICE: Do not mistake orange flames with yellow tipping. Dirt or other fine particles are burned by appliance, causing brief patches of orange flame.
If burner flame pattern is incorrect, as shown in Figure 30, page 16.
•turn appliance off (see To Turn Off Gas to Appliance, page 14)
•see Troubleshooting, page 18
Yellow Flames with
Orange Streaks
| Figure 27 - Gas Module Left Side | Figure 29 - Correct Burner Flame Pattern |
|
www.fmiproducts.com | 15 | ||