W26LTF Wall Mantel and Base
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Important: Read entire instruction sheet before assembling or installing mantel kit.
This mantel is only approved for use with any Comfort Glow 26" intermediate fireplace system, Dimplex Electric 26" intermediate fireplace and Style Selections 26" intermediate fireplace. Do not use mantel with any other product.
This mantel kit contains the following:
•Mantel pieces - unassembled and marked as follows: #1 Base
#2 Right Side with arrow
#3 Right Front Leg with arrow #4 Left Side with arrow
#5 Left Front Leg with arrow #6 Header with arrow
#7 Top
#14 Style Selections Filler Panel (for use with Style Selec- tions gas fireplace model #256032 only)
#15 Filler Panel Assembly Block (3 pieces)
•Hardware Kit*
16 | - Metal Brackets | |
32 | - Screws M6 x 12 mm (1/2") | |
13 | - Screws M6 x 30 mm (1 1/4") | |
13 | - Washers M6 | |
1 - Allen Wrench | ||
*Extra hardware may be included.
If any wood pieces are missing or damaged, contact the dealer where you purchased this mantel for replacement. If hardware is missing or damaged, contact DESA Heating Products at
Note: Gather all mantel pieces together before assembling mantel.
WARNING: Use only 1/2" screws to attach metal angle brackets. Damage to mantel will result if other screws are used for this purpose.
Assembling Mantel
IMPORTANT: More than one person is required to assemble and lift mantel.
Estimated assembly time: 30 minutes.
When assembling mantel do not tighten screws completely until told to do so. There should be some play in the pieces to allow for proper alignment and best possible fit. It is very importantthatmorethanonepersonassemblemanteltogether. Panels must be held in proper alignment to each other while tightening screws to assure fewer gaps and proper surface alignment. When tightening screws, do not over tighten. This may cause threads to strip. For this reason, the suppliedAllen wrench should be used rather than a power screwdriver. The panels have threaded inserts installed to mark your screw locations. Screws should start and turn easily in threaded holes when assembled according to instructions. Do not force screws into holes.
IMPORTANT: There is a serial number label inside of right side panel and on outside package. When calling to request technical assistance or for replacement parts please have that number ready.
www.desatech.com