Filler Panel Assembly (for use with Style Selections gas fireplace only)
If you are installing a Style Selections Gas Fireplace in this mantel, you will need to follow the instructions in this section. If you are not installing a Style Selections Gas Fireplace, go to Mantel Top Assembly and discard items #14 and #15.
1.Place Style Selections filler panel (#14) in position in front of mantel with trim strip to outside covering joint between filler panel and mantel (see Figure 4).
2.With one person holding filler panel in place, attach filler assembly (#14) to bottom of header mantel side using 3 filler panel blocks #15 and six 1 1/4" screws with washers (see Figure 4). Do not tighten screws.
1 1/4" Screw with Washer | Filler Panel (#14) |
Back View
Filler Panel (#14)
Figure 4 - Attaching Style Selections Filler Panel
Mantel Top Assembly
Place mantel top (#7) on mantel assembly. Align back of top with back of sides. Using seven 1 1/4" screws with washers, place two in each mantel side assembly and three in the header (see Figure 5). Make sure all pieces are aligned properly and tighten all seven screws.
Mantel Top (#7)
Washer
1 1/4"
Screw
Mantel
Side
Assembly
Figure 5 - Attaching Mantel Top
electric Fireplace Installation
This mantel can be used with a 26" intermediate Fireplace. Electric fireplaces install from the front of mantel. To install electric fireplace see fireplace instruction manual.
www.desatech.com |