<Notes on care of disc>

If there is a dust, dirt or fingerprints on the disc, which may cause error in playback or recording, wipe the disc with a soft, dry cloth or alcohol from the center out.

Never wipe from the outside to center.

Do not use a cleaner for analog discs or antistatic spray, as well as volatile solvents such as benzine, which may damage the disc surface.

Do not expose any disc to direct sunlight, or leave it in hot, moist or cold places.

Read the attached manual packed with the disc before using it.

How to install the CD-1A

<Notes on installing the CD-RW drive>

The CD-RW drive is made of precision parts.

Do not apply a mechanical shock or use excessive force when installing it.

Before installing the drive, make sure that the power of the VF-160 is off and the power cord is disconnected.

Install the drive correctly according to this manual.

Note that damage to the drive caused by inappropriate installation is not covered by the guarantee.

1

Place the VF160 upside down on a material such as a soft cloth, and unscrew the screw that fixes the blank panel.

Be careful not to drop the VF160 or give a strong shock to the VF160, which may dam- age the hard-disk drive built into it.

Keep the blank panel for future use in case you unmount the CD-1A.

Unfasten the screw that fixes the blank panel.

Blank panel

Remove the blank panel.

2

Turn the VF160 over and insert the CD-1A into the slot on the front panel.

Push the CD-1A firmly, without forcing, so that the connector of the CD-1A fits into its companion in the slot.

connector

CD-1A

Keep the screw mentioned above, which will be used in step 4 below after install- ing the CD-RW drive.

3

Page 3
Image 3
Fostex installation manual How to install the CD-1A