Installing of the chimney and fixing of the hood
When the hood is installed in recycling version the chimney has to be positioned with the slots upwards. When the hood is in- stalled in ducting version it has to be positioned in the opposite way.
•Place the chimney on the frame and fix it to the upper part of it with the earlier removed screws. When installing the hood in recycling version make sure that the slots correspond to the air outlet of the recycling air outlet piece 15.
•Open the lighting unit by slightly pulling the notch. Remove the unit from the hood by sliding the fixing pivot.
•Remove the filter pushing it towards the back side of the hood unit and simultaneously pulling downwards.
•Remove possible charcoal filters.
•In order to fix the hood body to the frame insert the 4 screws 12f in their seats. It is necessary to leave at least 3/16”gap be- tween the screw heads and the frame plate.
•Hook the hood canopy to the frame and turn it to the left until it reaches the stop, then lock the screws immediately to prevent the hood canopy from falling out accidentally.
Electrical connection
•Remove the cover from the Field Wiring Compartment with a phillips screwdriver.
•Feed the Power Supply Cable through the electrical knockout. Connect the Power Supply Cable to the range- hood cable. At- tach the Power Supply Cable grounding lead to the green screw provided. Attach the White lead of the power supply to the White lead of the rangehood with a
•Replace the cover.
| 1 |
| 2 |
Green | Ground wire |
Ground |
|
screw |
|
Power supply cable
• Connect the
Lux
• Connect the
Cmd 
EN |
| 1 |
| 12 |
