Place Door 1 on top of the unit in closed position, aligning the brackets on the door
edge with the brackets on the upper edge of the unit. Push or tap each pin so that it
slides into the bracket on the door. Once the pins are fully inserted, they cannot be
removed easily. Repeat with Door 2.
4. Screw the four handle-holders into place on both sides of unit, using supplied screws.
5. Fit the two handles over handle-holders and tighten them with the supplied screws.
Installation
If possible, avoid placing the cart directly beside heat sources such as barbecue grills or in
direct sunlight since this will cause the compressor to run for long periods. If located near a
source of heat, maintain the following minimum clearances:
From barbecue grills or heaters: 12“
From freezers or refrigerators: 4”
Sufficient room must be allowed around the appliance to ensure free circulation of air.
Locate the cart on a dry, solid, level surface. Once it is in position, the two casters at the
front should be locked.
Be sure the exhaust grill remains unblocked while the appliance is in use.

Electrical Connection

Plug the power cord into a dedicated 3-slot, 120VAC outlet that will accept the plug. The
Power ON light will go on.
Important! For your personal safety, this appliance must be properly grounded. In
the event of an electrical short circuit, grounding reduces the risk of shock by providing an
escape wire for the electric current. This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must be inserted into an outlet that is
properly grounded and installed. The ground wire cannot be connected to a gas pipe,
heating pipe, water pipe, telephone line or lightning rod. It cannot be replaced with the
neutral wire of single-phase power. In addition to the ground wire, an electrical leakage
circuit breaker is also required. Consult a qualified electrician if you do not completely
understand these grounding instructions.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD.
If installation in a damp location is unavoidable, have an electrician install a ground fault
circuit interrupter (GFCI) electrical outlet. If no GFCI is installed, electrical shock could result.
Do Not Use an Extension Cord
Avoid the use of an extension cord because of potential safety hazards under certain
conditions.
5