Automatic shut off
The dehumidifier will turn off automatically when the bucket is full, removed or not replaced in the proper position.
The bucket must be replaced in the proper position for the dehumidifier to work. The light will be on and the dehumidifier will not run if the bucket is not in the proper position.
Water level
control switch
Disposing of collected water (3 methods)
1. Empty the bucket manually.
When the bucket is full, pull out and empty it into a large sink or tub and then replace it properly.
NOTE: The bucket must be positioned properly making sure slots on the back of bucket are positioned correctly.
NOTE: Do not overtighten the hose when connecting it to the bucket. Use a rubber washer and tighten by hand firmly without stripping the plastic threads.
2. Place the dehumidifier directly over drain.
The bucket has a threaded hose connection which can be left open. Drill a 1/4" (6.4 mm) hole in the center of the hose connection. Once opened, the hose connection will continually drain water from the bucket.
NOTE: The nozzle cannot be fixed after puncture. Use an ordinary garden hose cap to reclose if necessary.
3. Attach a length of garden hose to the threaded bucket drain hose connection to carry water to the drain.
When being attached to the bucket drain hose connection, be sure the hose doesn’t kink or bend. It should lie flat from the dehumidifier to the drain.
NOTE: The hose attachment will accept a standard garden hose filling. You can attach a
Drill
7
