Avoid Service Checklist

Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not the result of defective workman-ship or materials in this appliance.

OCCURRENCESOLUTION

Air conditioner will not operate.

Wall plug disconnected. Push plug firmly into wall outlet.

Plug Current Device Tripped. Press the RESET button.

House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker.

Selector Control in OFF position. Turn selector to ON (some models) or the desired FAN or COOL setting.

Unit turned off by moving thermostat to a higher number and then immediately turning back to a colder number. Wait approximately 3 minutes. Listen for compressor to start.

Unit turned off and then on too quickly. Turn unit off and wait 3 minutes before restarting.

Thermostat set too low. Adjust thermostat to higher number for cooling.

Air from unit does not feel cold enough.

Turn selector to a higher COOL position

Thermostat set too warm. Set thermostat to colder temperature.

Room temperature below 60°F (16°C). Cooling may not occur until room temperature rises above 60°F (16°C). Temperature sensing tube touching cold coil, located behind air filter. Straighten tube away from coil.

Air conditioner cooling, but room is too warm - ice forming on cooling coil behind decorative front.

Outdoor temperature below 60°F (16°C). To defrost the coil, set selector to FAN position. Then, set thermostat to warmer position.

Air filter may be dirty. Clean filter. Refer to Care and Cleaning section. To defrost, set selector to FAN.

Thermostat set too cold for night-time cooling. To defrost the coil, set selector to a FAN position. Then, set thermostat to a warmer position.

Air conditioner cooling, but room is too warm - NO ice forming on cooling coil behind decorative front.

Dirty air filter - air restricted. Clean air filter. Refer to Care and Cleaning section.

Thermostat set too warm. Turn thermostat clockwise to a colder setting.

Air directional louvers positioned improperly. Position louvers for better air distribution.

Front of unit is blocked by drapes, blinds, furniture, etc. - restricts air distribution. Clear blockage in front of unit.

Doors, windows, registers, etc. open - cold air escapes. Close doors, windows, registers, etc.

Unit recently turned on in hot room. Allow additional time to remove “stored heat” from walls, ceiling, floor and furniture.

Air conditioner turns on and off rapidly.

Dirty air filter - air restricted. Clean air filter.

Outside temperature extremely hot. Set to high cool to bring air past cooling coils more frequently.

Noise when unit is cooling.

Air movement sound. This is normal. If too loud, turn selector to lower FAN setting.

Sound of fan hitting water-moisture removal system. This is normal when humidity is high. Close doors, win- dows and registers.

Window vibration - poor installation. Refer to installation instructions or check with installer.

Water dripping INSIDE when unit is cooling.

Improper installation. Tilt air conditioner slightly to the outside to allow water drainage. Refer to installation instructions - check with installer.

Water dripping OUTSIDE when unit is cooling.

Unit removing large quantity of moisture from humid room. This is normal during excessively humid days.

Room too cold.

Thermostat set too high, set to a lower number on temperature dial.

If These Solutions Fail, Call 1-800-444-4944 For Frigidaire Service.

7

SZ000710(En)-JiXie

8

2005.9.13, 11:04 AM

Page 7
Image 7
Frigidaire 220211A177 manual Avoid Service Checklist

220211A177 specifications

The Frigidaire 220211A177 is a versatile and reliable appliance designed to meet the needs of modern households. This model embodies advanced technology and thoughtful engineering, ensuring it stands out among its competitors.

One of the most notable features of the Frigidaire 220211A177 is its efficient performance. It is equipped with Energy Star certification, underscoring its commitment to energy conservation. This means reduced electricity consumption, translating to lower utility bills for families while also contributing to environmental sustainability.

The design of the Frigidaire 220211A177 is sleek and contemporary, making it suitable for various kitchen aesthetics. Its exterior often includes a fingerprint-resistant finish, which not only enhances its look but also minimizes the time spent on upkeep. This finish helps maintain the appliance’s appearance, allowing users to enjoy a clean and polished look without frequent wiping.

In terms of functionality, the Frigidaire 220211A177 is designed to maximize storage space. It features adjustable shelves, allowing users to customize the interior layout according to their specific needs. This flexibility ensures that the refrigerator can easily accommodate items of varying sizes, from tall bottles to small containers.

Another key characteristic is the advanced cooling technology utilized in its design. The precise temperature control and even air circulation help preserve food freshness for a more extended period. The appliance often employs a moisture control feature, which is essential for maintaining optimal humidity levels within the refrigerator.

Convenience is enhanced through several user-friendly options. Many models, including the 220211A177, offer quick access to water and ice dispensers without needing to open the door. This feature not only saves energy but also adds convenience for busy households.

Furthermore, the Frigidaire 220211A177 typically includes smart features that enable connectivity with mobile apps, allowing users to monitor and manage appliance settings remotely. This connectivity enhances user experience by providing updates on food storage conditions, energy usage, and alerts if temperatures fluctuate unexpectedly.

In summary, the Frigidaire 220211A177 is an excellent choice for anyone seeking a reliable, efficient, and modern refrigerator that combines thoughtful design with advanced technology. Its features cater to the varying needs of households, promoting convenience, energy-saving, and smart living.