Frigidaire 220211A243 continued, Check Filter Feature, Clean Air Feature, You Will See, LIGHT On

Air Conditioner Features

(continued)

CHECK FILTER FEATURE: YOU WILL SEE:

LIGHT On

DO THIS:

AFTER CLEANING

PRESS CHECK

FILTER BUTTON

. .

Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the “Check Filter” button and the light will go off.

CLEAN AIR FEATURE

(on some models):

. DO THIS:

PRESS CLEAN

AIR BUTTON

YOU WILL SEE:

LIGHT On

Note: When this feature is “ON”, the electronic air purifier is energized to remove pollen and impurities from the air. To cancel this feature, press the Clean Air button (the LIGHT will turn

.

off).

REMOTE SENSING/FOLLOW ME FEATURE

(on some models) : LIGHT pulsing On & Off intermittently.

		SET TEMP.
ON			F
OFF
FAN SPEED
Mode			Fan
Energy Saver			Timer
Clean Air			Cancel
Follow Me	Reset	Lock	Clock
Sleep		Light

DO THIS:

PRESS REMOTE SENSING/FOLLOW ME

BUTTON ON

Note: Unit display shows “set” temperature

.

		SET TEMP.
ON			F
OFF
FAN SPEED
Mode			Fan
Energy Saver			Timer
Clean Air			Cancel
Follow Me	Reset	Lock	Clock
Sleep		Light

NOTE: Remote display is actual temperature at remote control only.

Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.

To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing button. Next, use the buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself). The

LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal. It will con-tinue to send this signal until the feature is deactivated by pressing the remote sensing button. If the unit does not receive the remote sensingsignal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY. The unit display indicates the set temperature.

9