Locating the Filters

Your refrigerator is equipped with water filtering system. The water filter system filters all dispensed drinking water, as well as the water used to produce ice.

Water Filter

The water filter is located at the top right side of the fresh food compartment.

Replacing the Water Filter

In general, you should change the water filter every six months to ensure the highest possible water quality. Water Filter Status on the user interface prompts you to replace the filter after a standard amount of water

(200 gallons/757 liters for PureSource 3TM) has flowed through the system.

If your refrigerator has not been used for a period of time (during moving for example), change the filter before reinstalling the refrigerator.

Ordering Replacement Filters

To order your replacement filters, please visit our online store at www.frigidaire.com/store, by calling toll-free at 877-808-4195, or by visiting the dealer where you purchased your refrigerator. Electrolux recommends that you order extra filters when you first install your refrigerator, and that you replace your filters at least once every six months.

Here is the product number to request when ordering:

PureSource 3TM Water Filter

Part #WF3CB

CHANGING THE FILTER

More about your Advanced Water Filter

The PureSource 3TM ice and water filter system is tested and certified to NSF/ANSI Standards 42 and 53 for the reduction of claims specified on the performance data sheet.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

Test & certification results:

•Rated Capacity - 200 gallons/757 liters for PureSource 3TM ice and water filter

•Rated service flow - .50 gallons per minute

•Operating Temp.: Min. 33°F, Max. 100°F

•Maximum Rated Pressure - 100 pounds per square inch

•Recommended Minimum Operating Pressure: 30 pounds per square inch

To replace your PureSource 3TM water filter:

It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement.

1Turn Off the ice maker power switch.

2Remove the filter by pushing on the end/face of the filter.

3Slide the old water filter cartridge straight out of the housing and discard it.

4Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.

5Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector).

6Press a drinking glass against the water dispenser while checking for any leaks at the filter housing.

Any spurts and sputters that occur as the system purges air out of the dispenser system are normal.

7After filling one glass of water, continue flushing the system for about four minutes.

8Turn On the ice maker.

9Press and hold the Water Filter button on the Ice & Water Dispenser control panel for three seconds. When the display changes from Red to Green, the status has been reset.

15

Page 14 Page 16
Page 15
Image 15
Frigidaire 242063600 Locating the Filters, Replacing the Water Filter, Ordering Replacement Filters
Page 14 Page 16

242063600 specifications

The Frigidaire 242063600 is a highly efficient refrigerator water filter that provides a convenient solution for ensuring clean and safe drinking water. Designed for compatibility with various Frigidaire and Electrolux refrigerators, this water filter is a reliable choice for improving the quality of water dispensed from your refrigerator.

One of the key features of the Frigidaire 242063600 is its advanced filtration technology. This filter utilizes a multi-stage filtration process that effectively reduces contaminants from water, including chlorine, lead, and other impurities. This helps to enhance the taste and odor of the water, making it not only safe to drink but also refreshing.

The installation process of the Frigidaire 242063600 is designed to be user-friendly. It features a simple "push-pull" design that allows users to easily replace the filter without the need for specialized tools. This ease of installation ensures that homeowners can quickly access filtered water without the hassle of complicated setups.

In terms of lifespan, the Frigidaire 242063600 water filter generally lasts for approximately six months, depending on the frequency of use and the quality of the water being filtered. Regular replacement of the filter is crucial to maintaining optimal performance and ensuring continued water purity. The filter is also designed to provide a flow rate that is sufficient for everyday use, ensuring that you won't run out of clean water when you need it the most.

Another characteristic of this water filter is its eco-friendly design. By choosing a water filter over bottled water, consumers can significantly reduce plastic waste and minimize their environmental footprint. The Frigidaire 242063600 aligns with this trend by providing a sustainable alternative for families looking to maintain access to clean water while being mindful of their impact on the planet.

Incorporating the Frigidaire 242063600 into your refrigerator not only promotes healthier drinking habits but also contributes to a more sustainable lifestyle. With its impressive filtration capabilities, straightforward installation, and environmental benefits, this water filter is a valuable addition for anyone seeking enhanced water quality at home.
Top Page Image Contents