Frigidaire 316901303 important safety instructions To assemble the Effortless Oven Rack system

Effortless™ Oven Rack system

Some models are equipped with a special oven rack system that automatically partially extends the oven rack from the interior oven glides to assist in easier access to your food items. This feature works whenever the oven door is opened or closed.

To assemble the Effortless™ Oven Rack system:

1.	Locate all required parts. You will need the supplied
	oven rack (Effortless™ Oven Rack is a flat rack with a
	special dark coating on the left and right rack
	sides) and the 2 supplied chrome connector arms.
2.	Open the oven door. Be sure the oven is completely
	cool before proceeding.
3.	Place the oven rack in positions 2, 3 or 4 only (see
	previous page to verify positions).Be sure the rack
	connector brackets are at the rear of the range and
	pointing towards oven bottom (See Fig. 2).
4.	Assemble one connector arm at a time. With the oven

BEFORE SETTING OVEN CONTROLS

IMPORTANT

Only the Effortless™ Oven Rack system should be used in oven rack position 2. Placing ANY other rack in oven rack position 2 will prevent the oven door from fully closing and may damage the oven door, oven cavity or the door connector brackets.

If the rack system is not assembled with the connector arms the Effortless™ Oven rack may be used in oven rack positions 2 thru 6. Do not attempt to use the Effortless™ Oven rack in rack position 1.

door	rack connector
connector	bracket
bracket

	door open and the oven rack in place, install one end of
	the connector arm to the hole in the door connector
	bracket (Fig. 1) and the other end in the hole in the
	rack connector bracket (Fig. 2 and as in Fig. 3). The
	oven rack may need to be adjusted in or out in the rack
	position to match the length of the connector arm.
5.	While holding the connector arm in place, twist the
	connector arm so the ends of the connector arm point
	upwards (See Figs. 4 & 5). The connector arm should
	now be locked into position.
6.	Repeat steps 4 and 5 for the other connector arm.
7.	Once both connector arms are properly in place, be

Fig. 1

connector

arm

Fig. 3 - assembly of the Effortless™ Oven Rack

Fig. 2

oven rack

sure to test the oven rack operation by gently closing

the oven door. The oven rack should move in and out of

the oven freely when the door is opened or closed.

open oven	connector
door	arm

CAUTION

REMOVE ALL OVEN RACKS and accessories before starting a self-clean cycle. If the oven racks are left in the oven during the self-clean cycle, the glide ability of the Effortless™ Oven Rack system will be damaged and will cause oven racks to loose their shiny finish and or turn blue. Remove ALL oven racks and clean according to instructions provided in the Care & Cleaning section of this manual.

Make sure the oven and oven racks are COMPLETLY cool and safe to touch before attempting to assemble or disassemble the Effortless™ Oven Rack system. Never pick up hot oven rack parts.

connector arm

Fig. 4

connector

arm

Fig. 5

left and right

door connector

brackets

with connector arm ends shown in locked position (pointing upwards)

Fig. 6 - Effortless™ Oven Rack after assembly

9