GAS COOKTOP INSTALLATION INSTRUCTIONS
Important Notes to the Installer
1.Read all instructions contained in these installation instructions before installing the cooktop.
2.Remove all packing material before connecting the electrical supply to the cooktop.
3.Observe all governing codes and ordinances.
4.Be sure to leave these instructions with the consumer.
5.Note: For operation at 2000 ft. elevations above see level, appliance rating shall be reduced by 4 percent for each additional 1000 ft.
Important Note to the Consumer
Keep these instructions with your Use and Care Guide for future reference.
IMPORTANT SAFETY
INSTRUCTIONS
Installation of this cooktop must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code ANSI
This cooktop has been design certified by American Gas Association (A.G.A.). As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You will find them in the Use and Care Guide, read it carefully.
•Be sure your cooktop is installed and grounded properly by a qualified installer or service technician.
•This cooktop must be electrically grounded in accordance with local codes or, in their absence, with the National Electrical Code ANSI/NFPA No.
•The burners can be lit manually during an electrical power outage. To light a burner, hold a lit match to the burner head, then slowly turn the Surface Control knob to LITE. Use caution when lighting burners manually.
•Do not store items of interest to children in the cabinets above the cooktop. Children could be seriously burned climbing on the cooktop to reach items.
•To eliminate the need to reach over the surface burners, cabinet storage space above the burners should be avoided.
•Adjust surface burner flame size so it does not extend beyond the edge of the cooking utensil. Excessive flame is hazardous.
•Never use your cooktop for warming or heating the room. Prolonged use of the cooktop without adequate ventilation can be hazardous.
•Do not store or use gasoline or other flammable vapors and liquids near this or any other appliance. Explosions or fires could result.
The electrical power to the cooktop must be shut off while line connections are being made. Failure to do so could result in serious injury or death.
1. Wall Outlet | 12" |
|
| (30.5 cm) |
|
|
|
|
|
|
| ||
Location |
|
| 8" |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| |||||
NOTE: If an outlet |
|
|
| (20.3 cm) |
|
|
|
|
|
|
| ||
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
| 10" |
|
| ||
is not available, |
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| (25.4 cm) |
|
| |||
have one installed |
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| |
by a qualified |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
technician. |
|
|
|
| Recommended |
| |||||||
|
|
|
|
|
| ||||||||
|
|
|
| area | for 120V |
|
|
|
| ||||
|
|
|
|
|
| ||||||||
|
|
|
| grounded |
|
|
|
| |||||
|
|
|
| outlet on rear | 22" | ||||||||
|
|
|
| wall | |||||||||
|
|
|
|
| (55.9 cm) | ||||||||
|
|
|
|
|
|
|
|
|
|
|
CL of unit
CL of unit
Figure 3
2. Installation
Insert the cooktop into the countertop opening.
Note: After inserting the cooktop into the countertop opening, make sure the unit is sitting on the metal flange around the top of the burner box. Cooktop must not sit on the porcelain top. Avoid cutting an oversized hole in the countertop.
3. Clamp Down Information
Once the cooktop is installed in the counter opening, you must clamp the unit down as shown.
CooktopCountertop
Angle Bracket
Thumb Screw
Figure 4
To clamp down, insert the bracket with the offset side of the angle into the slots on each side of the unit. The thumb screw should then be run through the bracket, up against the bottom of the counter. Tighten until the unit draws down.
3