Frigidaire 318201534 Cabinet Installation, Model and Serial Number Location, Important Note

MICROWAVE/ WALL OVEN COMBINATION

INSTALLATION INSTRUCTIONS

If oven is used in a new branch circuit installation (1996 NEC), mobile home, recreational vehicle, or where local codes do not permit grounding through the neutral (white) wire, the appliance frame MUST NOT be connected to the neutral wire of the 4-wire electrical system. (see figure 4):

1.Disconnect the power supply.

2.Separate the green (or bare copper) and white appliance cable wires.

3.In the junction box:

connect appliance and power supply cable wires as shown in Figure 4.

Cable from Power Supply

Ground Wire

Red	White Wire
Wires
	Black
	Wires
Ground Wire
(Bare or Green
Wire)	White Wire
Junction Box	U.L.-Listed Conduit
Cable from appliance	Connector (or CSA
	listed)
Figure 4

4-WIRE GROUNDED JUNCTION BOX

Model and Serial Number Location

The serial plate is located along the interior side trim of the oven and visible when the door is opened.

When ordering parts for or making inquires about your oven, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your oven.

Serial Plate

Location

4. Cabinet Installation

IMPORTANT NOTE

Do not lift the oven by the door handle.

Heavy Weight Hazard

•Use 2 or more people to move and install wall oven.

•Failure to follow this instruction can result in injury or damage to the unit.

1Unpack the wall oven. Remove the bottom trim taped on the oven side panel.

2Find the 2 anti-tip mounting screws included in the literature package.

3Insert the oven into the cabinet opening. Slide oven inward leaving 1½" (3.8 cm) clearance between the oven and front of cabinet (see Figure 5).

4Pull the armored cable through the hole for it in the cabinet and toward the junction box while moving the appliance inward.

5Push the oven in and against the cabinet.

1½" (3.8 cm)

clearance between unit

Figure 5

4