Setting Surface Controls
Models with Ceramic Glass Cooktop (continued)
Operating the Dual Surface Radiant Element (Models with Ceramic Glass Cooktop Only)
Model A is equipped with Dual radiant surface elements at all positions (See Figs. 5 & 6). Models B, C, D & E are equipped with a dual radiant surface element located at the right front (See Figs. 7 to 14) position. Symbols on the control panel are used to indicate which coil of the dual radiant element will heat. The 
symbol indicates that only
the inner coil will heat (Figs. 1, 3, 5, 7, 9, 11 & 13). The 
symbol indicates that both inner and outer coils will heat (Figs. 2, 4, 6, 8, 10, 12 & 14). You may switch from either coil setting at any time during cooking.
Small | |
Element | |
| Fig. 1 |
Smal l | Large |
Petit | OFF Grand |
hi | hi |
6 | 6 |
4 | 4 |
2 | 2 |
l o | l o |
Fig. 3
Large | |
Element | |
| Fig. 2 |
Smal l | Large |
Petit | OFF Grand |
hi | hi |
6 | 6 |
4 | 4 |
2 | 2 |
l o | l o |
Fig. 4
To Operate the Dual Surface Element:
1.Place correctly sized cookware on the dual surface element.
2.Push in and turn the control knob counterclockwise (See Fig. 3) for smaller cookware or clockwise (See Fig. 4) for larger cookware.
3.Turn the knob to adjust the setting if needed. Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.
4.When cooking has completed, turn the surface control knob to OFF before removing the cookware. Note: The Surface Indicator light will come on when the control knob will be turn on and will continue to glow until the glass cooktop has cooled down to a moderate level. The light may remain on even though the controls are turned OFF.
Note: See page 9, Fig. 1 for recommended control settings.
Radiant surface elements may appear to have cooled after they have been turned off. A hot surface indicator light will come on and will continue to glow until the glass cooktop has cooled down to a moderate level. The glass surface may still be hot and burns may occur if the glass surface is touched before the indicator light has turned off.
