![](/images/new-backgrounds/1087116/8711627x1.webp)
Care & Cleaning
To Remove the “Hidden Bake” Cover (some models)
1.In order to remove the “hidden bake” cover, pull the back edge with one hand about 1/2" inch and lift up the “hidden bake” cover with both hands. (See picture)
2.When
To have easier access to the "hidden bake" cover, you can remove the oven door by following the instructions on previous page.
IMPORTANT: Always replace the “hidden bake” cover before the next use.
Adjusting Your Oven Temperature
For instructions on how to adjust the oven temperature refer to the electronic oven control guide.
Before you call
Solutions to Common Problems
OCCURRENCE | POSSIBLE CAUSE/SOLUTION |
|
|
Oven Control Beeps and Displays any F code (for example F11).
Electronic control has detected a fault condition. Push CLEAR pad to clear the display and stop the display from beeping. Reprogram the oven. If a fault reoccurs, record the fault number, push the CLEAR pad and contact an authorized servicer.
-F8- is displayed.
The door was left open and controls set for
Installation. | Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent |
| if rack and cabinet cutout flooring are not level. |
|
|
| Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are |
| square and level. Contact cabinet maker to correct problem. |
Entire oven does not operate.
When the oven is first plugged in, or when the power supply to the oven has been interrupted, the display will flash. The oven cannot be programmed until the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact your dealer, installing agent or authorized servicer.
Service wiring not complete. Contact your dealer, installing agent or authorized servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under Setting Oven Controls to set the controls.
14