Direct Draining
Direct Draining
If you want the water to flow directly to a drain, you must first remove the hose cap (Figure 2). To remove hose cap, use a standard screwdriver and turn counter- clockwise. Connect any standard garden hose to the bucket connection, or place the dehumidifier over the drain. A standard garden hose has a 3/4” (19 mm) diameter connection with 111¼2 inch threads per inch.
Note: When using either of the above direct draining methods, you must first drill a 3/8” (10 mm) hole in the center of the bucket connection. (For ease of drilling use locating mark to center drill bit for hole (Figure 3).) This will allow water to flow freely through the connection. To reseal the hose connection to the bucket, use any standard hose end cap. The hose cap cannot be used to reseal the hole.
Locating
Hole
Figure 4 | Figure 5 |
Care and Cleaning
Proper Care
Before cleaning, be sure to turn off and unplug unit.
1.Dust outer cabinet with an
2.Use a vacuum cleaner and brush attachment to clean grill.
Note: Fan motor has been permanently lubricated at the factory.
Air passing through dehumidifier may carry quantities of dust, lint and fungus spores. Much of this matter will be deposited on the coil and then flushed away by natural drainage.
6