Frigidaire A01060901 Changing The Filter, Connecting Water Supply, PURE ADVANTAGE Air Filter

CHANGING THE FILTER

PURE ADVANTAGE™ Air Filter

Your new Pure Advantage air filter is located inside one of the 2-Liter Door Bins. The air filter cover is located on the upper right side of the control box. In general, you should change the air filter with Part Number “EAFCBF” every six months to ensure optimal filtering of freezer odors. The replacement air filter can be purchased on the Frigidaire website (http:// frigidaire.stores.yahoo.net) or call toll free in the U.S. and Canada: 1-800-599-7569. Your electronic control is equipped with a Replace Filter indicator to remind you to change your filter. See ELECTRONIC CONTROL section.

To Install Or Replace The Air Filter

•Pull down on the front of the Pure

Advantage™ air filter cover to release the hinged bottom cover.

•Allow bottom cover to swing open and then remove the old filter and discard it.

•Unpackage the new filter and place it inside the hinged bottom cover of the housing.

•Push the hinged bottom cover upward until the tab snaps into closed position.

reset
			press & hold
ir	temp
er		alarm
	mode		control
air filter		off
			lock

Open Air Filter Cover

Air Filter

Remove Air Filter

CONNECTING WATER SUPPLY

WARNING

To avoid electric shock, which can cause death or severe personal injury, disconnect the freezer from electrical power before connecting a water supply line to the freezer.

CAUTION

•Copper or Stainless Steel braided tubing is recommended for the water supply line. Water supply tubing made of ¼ inch plastic is not recommended to be used. Plastic tubing greatly increases the potential for water leaks, and the manufacturer will not be responsible for any damage if plastic tubing is used for the supply line.

•DO NOT install water supply tubing in areas where temperatures fall below freezing.

•Chemicals from a malfunctioning softener can damage the ice maker. If the ice maker is connected to soft water, ensure that the softener is maintained and working properly.

NOTE

Ensure that your water supply line connections comply with all local plumbing codes.

Before Installing The Water Supply Line, You Will Need:

•Basic Tools: adjustable wrench, flat-blade screwdriver, and PhillipsTM screwdriver.

•Access to a household cold water line with water pressure between 30 and 100 psi.

•A water supply line made of ¼ inch (6.4 mm) OD, copper or stainless steel tubing. To deter- mine the length of tubing needed, measure the distance from the ice maker inlet valve at the back of the freezer to your cold water pipe. Then add approximately 7 feet (2.1 meters), so the freezer can be moved out for cleaning (as shown).

•A shutoff valve to connect the water supply line to your household water system. DO NOT use a self-piercing type shutoff valve.

•A compression nut and ferrule (sleeve) for con- necting a copper water supply line to the ice maker inlet valve.

12