Frigidaire APWD15N, APWD15A dimensions Front Load Washer Specifications, Optional Accessories

Front Load Washers

FAFW3577K W/B/R/N/A 3.5 Cu. Ft. Electric

Front Load Washer Specifications

•Product Shipping Weight (approx.) – 220 Lbs.

•An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (ANSI/NFPA 70) and local codes & ordinances. (Do not use same circuit as dryer.)

•Voltage Rating – 120V / 60 Hz / 15 Amps

•Amps @ 120 Volts = 8 Amps

•Equipped with 120V 3-wire power supply cord, approx. 60" long.

•Always consult local and national electric & plumbing codes.

•To maximize detergent effectiveness, ambient temperature should never be below 60° F.

•Can be installed alone, with or without optional 15" Drawer Pedestal, or stacked below matching Frigidaire® Affinity Dryer, which requires installation of optional Dryer Stacking Kit. (For installation details, refer to instructions included with optional pedestal or stacking kit or on web.)

•Can be built in with matching Frigidaire® Affinity Dryer in under- counter, recessed or closet installation. (Refer to Built-In Installations on this page for cutout dimensions. For additional installation details, refer to Product Installation Guide on web.)

•Closet installation requires vented door with 2 unobstructed louvered openings, minimum 60 sq. in. each, located 3" from top and bottom of door. Full-length 120 sq. in. opening also acceptable. Allow additional 1" clearance between fronts of units and closed door.

•Do NOT install in area exposed to dripping water or outdoor weather conditions, or where gasoline or other flammables, including automobiles, are kept or stored.

•Floor MUST be solid with 1" maximum slope. To minimize vibration or movement, reinforcement of floor may be necessary. Do NOT install on carpeted surface.

•Leveling legs supplied to level washer properly and reduce excessive noise and vibration.

•H/C water faucets MUST be installed within 43" of washer’s water inlet and MUST be 3/4" to connect to 48-1/2" inlet hoses.

•Water pressure MUST be between 30 and 120 psi with NOT more than 10 psi pressure difference between hot and cold.

•Drain required with standpipe diameter of 1-1/4" min. and height of 24" min. / 96" max. above floor, capable of eliminating 17 gallons per minute. Attached 52" drain hose can reach 74"-high standpipe. For higher standpipe, optional Drain Hose Extension Kit available.

Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions.

Optional Accessories

•Dryer Stacking Kit – (PN # 134700600).

•15" Classic White Drawer Pedestal – (PN # APWD15W).

•15" Classic Black Drawer Pedestal – (PN # APWD15E).

•15" Classic Red Drawer Pedestal – (PN # APWD15R).

•15" Classic Blue Drawer Pedestal – (PN # APWD15N).

•15" Classic Silver Drawer Pedestal – (PN # APWD15A).

•Mobile Home Installation Kit – (PN # 137067200).

•Drain Hose Extension Kit – (PN # 137098000).

FRIGIDAIRE®

USA • 250 Bobby Jones Expressway • Martinez, GA 30907	• 1-800-FRIGIDAIRE • frigidaire.com	Specifications
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4	• 1-800-265-8352 • frigidaire.ca
		subject to change.

FAFW3577K 10/09 © 2009 Electrolux Home Products, Inc. Printed in the U.S.A.