UNPACKING
1.Cut the shipping carton along the dotted line along the base of the unit.
2.While in the carton carefully lay the washer on its back side.
3.Removethe styrofoam base.
4.Carefully return the washer to an upright position and remove the carton.
5.Carefully move the washer to within 4 feet (122cm) of the final location.
6.Remove the following from the back side of the washer:
3 bolts,
3 yellow plastic spacers,
2 or 3 metal "P" clamps.
BOLT
SPACER
"P" CLAMP
7.Remove the service panel from the front of the washer.
8.Remove the 4 nuts and 6 large washers that attach the 2 yellow shipping braces to the drum and the base. Lift up on the drum and remove the braces (a yellow ribbon surrounds the items to be removed). These braces must be removed to allow the power supply cord to be released from the shipping ring.
9.Remove the large styrofoam block located under the drum. Lift up on the drum, tilt the base of the foam block inwards toward the rear of the washer until free, then pull it out.
10.Remove and discard the yellow ribbon and label from the front of the washer.
11.From the rear of the washer, carefully pull out the power supply cord through the hole in the backsheet.
12.Replace the service panel and screws.
NOTE: If the washer is to be transported at a later date, the shipping support hardware must be reinstalled to prevent shipping damage.
INSTALLATION
1.Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog up the water valve screens.
2.Remove the inlet hoses and rubber washers from the plastic bag and install the rubber washers in each end of the inlet hoses.
3.Carefully connect the inlet hose marked "HOT" to the outside "H" outlet of the water valve. Tighten by hand, then tighten another 2/3 turn with pliers. Carefully connect the other inlet hose to the inside "C" outlet of the water valve. Tighten by hand, then tighten another 2/3 turn with pliers. Do not
| crossthread or |
4. | Connect the inlet hose ends to the HOT and |
| COLD water faucets tightly by hand, then |
| tighten another 2/3 turn with pliers. Turn the |
| water on and check for leaks. |
6
