ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
Cooktop Installation
1.All Ceramic-Glass Cooktops
Visually inspect the cooktop for damage. Also make sure all cooktop screws are tight (see Figure 8).
SCREWS
Figure 8
Set the cooktop into the countertop cutout.
NOTE: Do not use caulking compound; cooktop should be removable for service when needed.
WARNING Do not remove the nylon spacers on the edges of the cooktop. These spacers center the cooktop in the space provided. The cooktop must be centered to prevent excess heat buildup that may result in heat damage or fire (see Figure 9).
6 NYLON SPACERS
POSITION BRACKETS
ON UNIT CUTOUT
CENTER LINE
2 RETAINER BRACKETS
Figure 9
The retainer brackets MUST be installed, to meet local codes or, in their absence, with the National Electrical Code ANSI/NFPA No.
COOKTOP | COUNTERTOP |
| Retainer Brackets Must |
| Be Installed At Least |
| 1/16" (0.16 cm) BELOW |
NYLON | Countertop |
| |
SPACER |
|
RETAINER |
|
BRACKET |
|
Figure 10 | |
2.Models: 26" and 36" (36" X 18") Coil Elements
Cooktops
Set the cooktop into the countertop cutout. Lift the cooktop and fasten the ends of the box to the counter with wood screws (figure 11). Lower the cooktop. Align the knobs on the shafts and press down with even pressure.
COOKTOPCOUNTERTOP
SCREW
BURNER BOX
Figure 11
3.Models: 32" Coil Elements Cooktops
1.Place cooktop into countertop opening and center unit in cutout.
2.Remove all surface units and drip bowls.
3.Unit clamp down information. Once unit is installed in counter opening, you must clamp unit down as shown in figure 12.
4.Put back all surface units and drip bowls.
5.Make electrical connections as outlined in "Electrical Connection" section.
5
