CONNECTING THE WATER SUPPLY
9.To turn ice maker on, lower wire signal arm (side mounted) or set the ice maker’s On/ Off power switch to the “I” position (rear mounted).
Plastic Water | Steel | |
Tubing to Ice | Clamp | |
Maker Fill | Brass | |
Compression | ||
Tube | ||
Nut | ||
| ||
| Ferrule | |
| (Sleeve) | |
| Copper | |
| water line | |
| Water Valve | |
| Bracket | |
| Valve Inlet | |
| Water Valve | |
| Copper water line | |
| from household | |
| water supply |
(Include enough tubing in loop to allow moving refrigerator out for cleaning.)
Figure 1
Plastic Water Tubing | Steel | |
to Ice Maker | ||
Clamp | ||
Fill Tube | ||
|
Stainless Steel water Line
Water Valve
Bracket
Valve Inlet
Water Valve
6 ft. Stainless Steel water line from household water supply
IMPORTANT
After connecting the water supply, refer to “How to Prime the Water Supply System” for important information about priming an empty water supply system.
Your refrigerator’s water supply system includes several tubing lines, a water filter, a water valve, and a water tank. To ensure that your water dispenser works properly, this system must be completely filled with water when your refrigerator is first connected to the household water supply line.
Figure 2
9