Operating Instructions

Using Air Conditioner To begin operating the air conditioner, follow these steps:

Set the temperature selector to the highest number (coldest or coolest setting). Set the mode control to the highest COOL setting.

Adjust the louvers for comfortable air flow (see Air Directional Louvers). Once the room has cooled, adjust the temperature selector to the setting you find most comfortable.

Review the “Operating Instructions” section for other settings.

Operating Instructions The controls featured in this manual are representative of many available models. Your model may offer slightly different features.

Temperature Selector

This is used to set the desired room temperature when the unit is being operated in the “COOL MODE”.

To set the desired room temperature, rotate the selector switch to the desired setting. After the set temperature is achieved, the thermostat will automatically start and stop the compressor in order to maintain the desired set temperature.

Rotate the temperature selector clockwise for higher cool setting. Higher cool settings will provide lower room temperature.

Rotate the temperature selector counter-clockwise for lower cool settings. Lower cool settings will provide higher room temperature.

Cool Mode

The desired cool setting is selected by rotating the MODE knob to the appropriate location. “High Cool” has maximum cooling effect and airflow.

“Med” has the intermediate cooling effect and airflow. “Low Cool” has minimum cooling effect and airflow.

Note:If your unit is equipped with a vent handle, keep it closed for maximum efficiency.

Fan Mode

Rotate the MODE knob to the left to select your choice of fan speeds for air circulation. Note: When selecting a fan speed, the compressor will not run. On models with a vent control, this mode can be used to remove stale air from the room, or to draw fresh air into the room. Check the section ‘Additional Things You Should Know’.

WARNING

Please always wait 3 minutes when turning unit off then on again, and when changing from cool to fan and back to cool. This prevents compressor from overheating & possible circuit breaker tripping.

Failure to follow these instructions may be harmful to your unit.

4

2009 Electrolux Home Products, Inc.

All rights reserved.

 

 

 

 

Page 4
Image 4
Frigidaire FRA102BT1, 2020215A0281 warranty Operating Instructions, Temperature Selector, Cool Mode, Fan Mode