Frigidaire FRS6B5EEQ2, FRS6B5EEQ3, FRS6B5EEQ5, FRS6B5EEQ7, FRS6B5EEW2, FRS6B5EEW3, FRS6B5EEW5, FRS6B5EEW7, FRS6B6EEB0, FRS6B6EEB5, FRS6B6EEB7, FRS6B6EEW0, FRS6B6EEW7, FRS6B7EESB8, FRS6B7EESB9, FRS6B7EESBN, FRS6L7EES9, FRS6L7EESN, FRS6L7EFS0, FRS6L9EESSN, FRS6L9EFSS0, FSC23R5DB5, FSC23R5DB7, FSC23R5DSB3, FSC23R5DSB4, FSC23R5DSB5, FSC23R5DSB7, FSC23R5DSB9, FSC23R5DSBN, FSC23R5DW5, FSC23R5DW7 INSTALLATION

This Owner’s Guide provides specific operating instructions for

your model. Use the refrigerator only as instructed in this Use &

Care Manual. Before starting the refrigerator, follow these

important first steps.

LOCATION

• Choose a place that is near a grounded electrical outlet.

Do Not use an extension cord or an adapter plug.

• If possible, place the refrigerator out of direct sunlight

and away from the range, dishwasher or other heat

sources.

• The refrigerator must be installed on a floor that is level

and strong enough to support a fully loaded refrigerator.

• Consider water supply availability for models equipped

with an automatic ice maker.

INSTALLATION

INSTALLATION

TOE GRILLE INSTALLATION / REMOVAL

To Install Toe Grille:

1. Open freezer and fresh food compartment doors.

2. Line up toe grille at base of refrigerator, making sure the

four bottom tabs are resting through holes at base of

cabinet.

3. Starting from left side of toe grille, press in on first top tab

using your thumb and push toe grille forward until it snaps

in place. Continue this process until all tabs are snapped

in place and toe grille is secured to refrigerator.

3. Check both doors to be sure seals touch cabinet on all four

sides.

LEVELING

All four corners of your refrigerator must rest firmly on a solid floor.

Your refrigerator is equipped with adjustable front rollers to help level

your unit. To ensure proper door seal and assist door closing, the

refrigerator should be tilted 1/4” (6 mm), front to back.

To Level Your Refrigerator:

1. Remove toe grille. (See

“To Remove Toe Grille”

2. Use flat-blade screwdriver or 3/8” socket wrench to adjust

front rollers.

To Remove Toe Grille:

1. Open freezer and fresh food compartment doors.

2. Working from left side of toe grille, slip your fingers

between top of toe grille and cabinet. Gently pull

forward until first set of

tabs are free. Slide

your hand down past

the free tabs and pull

forward again until the

second set of tabs are

free. Continue this

process until all tabs

are free and the toe

grille can be removed.

(See graphic at top of

page in right column.)

CAUTION CAUTION

CAUTION

Do Not install the refrigerator where the temperature

will drop below 55°F (13°C) or rise above 110°F (43°C).

The compressor will not be able to maintain proper

temperatures inside the refrigerator.

Do Not block the toe grille on the lower front of your

refrigerator. Sufficient air circulation is essential for the

proper operation of your refrigerator.

Installation Clearances

• Allow the following clearances for ease of installation,

proper air circulation, and plumbing and electrical

connections:

Sides & Top------------------ 3/8”

Back --------------------------- 1”

DOOR OPENING

NOTENOTE

NOTE

If you refrigerator is placed with the door hinge side

against a wall, you may have to allow additional space so

the door can be opened wider.

Your refrigerator should be positioned to allow easy access to a

counter when removing food. For best use of drawers and

freezer baskets, the refrigerator should be in a position where

both the refrigerator and freezer doors can be fully opened.

NOTENOTE

NOTE

The refrigerator doors are designed to shut by themselves

within a 20 degree opening.