Frigidaire pmn To Remove and Replace Oven Door, To Remove and Replace Warmer Drawer if equipped

General Cleaning

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove and Replace Oven Door

To Remove Oven Door:

1.Open the door.

2.Remove screws located on the inside of the oven door near the hinges A (one on each side.)

3.Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up and off the hinges.

4.To clean oven door, follow the instructions provided in the cleaning chart under General Cleaning

To Replace Oven Door:

1.Be sure the hinge arms are in the quarter-open position. Be careful if pulling the hinges open by hand. The hinges may snap back against the oven frame and could pinch fingers.

2.Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the door.

	3.	Hinge arms must go into the range slots evenly. The hinge arms should be
		inserted into the bottom corners of the door as far as they can go.
	4.	If the door is not in line with the oven frame, remove it and repeat the above
		steps.
	To Remove and Replace Warmer Drawer (if equipped)
	To Remove Warmer Drawer:
	1.	Turn power off before removing the warmer drawer.
	2.	Open the drawer to the fully opened position.
	3.	On the right glide you will find a shield attached with a hex-head screw (see
		figure 1). Using a 1/4” socket and ratchet remove the shield.
	4.	Locate glide lever on each side of drawer, pull up on the left glide lever and
		push down on the right glide lever.
	5.	Pull the drawer away from the range.
	To Replace Warmer Drawer:
	1.	Replace shield on the right glide of the drawer body.
	2.	Pull the bearing glides to the front of the chassis glide (see figure 2).
Figure 1	3.	Align the glide on each side of the drawer with the glide slots on the range.
	4.	Push the drawer into the range until levers “click” (approximately 2”). Pull
		the drawer open again to seat bearing glides into position. If you do not
		hear the levers “click” or the bearing glides do not feel seated remove
		the drawer and repeat steps 2-4.This will minimize possible damage to
		the bearing glides.
		Electrical Shock Hazard can occur and result in
		serious injury or death. Disconnect appliance from electric
		power before cleaning and servicing the warmer drawer.
Figure 2

19