FujiFilm J12, j10 or, flash, Flash, images, blurred, selected, pictures, , ,, ., 8, cannot be, FLASH] mode, The playback, The image is, Photographed, on the image

Matters	Problems			Possible causes				Solutions	Page
		The shutter button was pressed while the						Wait until the charging is completed	49
		flash was charging.						before pressing the shutter button.
	Cannot use the	The Shooting mode is set to				, ,,	,	Change the Shooting mode.	41
		,	, or .
	flash.
		The batteries have run out.						Load fully charged batteries.	12, 22
		The flash is set to [CSUPPRESSED						Set to another flash mode excluding the	48
		FLASH] mode.						[CSUPPRESSED FLASH] mode.
Flash
	The flash settings	The Shooting mode is set to AUTO,					,	The flash settings are restricted because
	are restricted and	, ,, ., 8,			, , ,	, ,	,	the camera settings are tailored to the	41, 49
	cannot be	,	or	.				scene being shot. Change the Shooting
	selected.							mode for a wider range of flash settings.
	The playback	The subject is too far away.						Move to within the effective flash range	47, 49
	image is dark							before taking the picture.
	even though the
		Your finger was covering the flash.						Hold the camera correctly.	25
	flash was used.
		The lens is dirty.						Clean the lens.	–
	The image is	{appeared when taking pictures.						Check the focus on the subject and take	26, 29,
								pictures.	107
	blurred.
Photographed
		appeared when taking pictures.						It may cause camera shake. Hold the	27, 107
images
								camera steadily.
	There is speckling	The picture was taken with a slow shutter						This is a characteristic of CCDs and does
		speed (long exposure) in a high-						not indicate a camera fault.	–
	on the image.	temperature environment.
								Continued Q
										Troubleshooting

113