2.For installation on the harsh environment case (HEC), remove the edge from the screen protector, as shown in Figure 4.
Figure 4. Removing Screen Protector Edge Strip
3.Peel the protective film from the adhesive side of screen protector as shown in Figure 5.
Figure 5. Removing Adhesive Backing
4.Apply the screen protector with the adhesive side down and the notch in the lower left corner as shown in Figure 6. Apply pressure along the edges of the screen protector with your finger. (Avoid lifting the screen protector from the display window after it is installed. The adhesive requires 48 hours to cure completely.
Figure 6. Applying the Screen Protector
5.Remove the protective film from the top surface of the screen protector as shown in Figure 7.
Figure 7. Peeling the Protective Film
6.Wipe the exposed surface of the screen protector with a clean dry cloth to remove any tacky residue left behind by the protective film. If necessary, clean the surface of the HEC window with a soft cotton cloth dampened with denatured alcohol to remove the residue.
Using the carrying strap and hand straps
The carrying strap assembly can be attached to either end of the HEC, depending upon your preference. Attach the clips to either the left or right set of
One or both of the two elasticized handstraps can be used. Slide your hand between one or both straps (whichever is most comfortable) and the HEC.
Handstraps
Figure 8. HEC Handstrap Assembly
2 of 2 |
