Fujitsu B2610 Primary Master Submenu of the Main Menu, Advanced, Security, Power, ESC Exit

L i f e B o o k B S e r i e s N o t e b o o k B I O S

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA/ ATAPI devices are installed.

Note: Actual hard drive label shown may vary. Depending on the drive type, information such as cylinders, heads and sectors may or may not be displayed.

		PhoenixBIOS Setup Utility
Main	Advanced	Security			Power	Boot	Info	Exit
	Primary Master [TOSHIBA MK2016GAP-(PM)]							Item Specific Help
Type:			[				Select ATA/ATAPI drive
				Auto]
Maximum Capacity:			20004MB				installed here.
Multi-Sector Transfers:			[16 Sectors]				[Auto]
LBA Mode Control:			[Enabled]				The BIOS auto-types the
PIO Transfer Mode:			[FAST PIO 4]				drive on boot time.
DMA Transfer Mode:			[Ultra DMA 2]				Except [Auto]
							You enter parameters of
							the drive.
							[None]
							The drive is disabled.

F1 Help	Select	Item
ESC Exit	Select	Menu

-/SpaceChange Values

Enter Select ▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 2. Primary Master Submenu

Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu

Menu Field	Options	Default	Description
Type:	• Auto	[Auto]	Selects the ATA/ATAPI device type. Select Auto to have the
	• None		type automatically identified by the BIOS at POST. If None is
	• Hard Disk		selected, all of the following Set-up items do not appear. If
			Hard Disk is selected, you must specify the number of Cylin-
			ders, Heads, and Sectors for the drive.
Cylinders:	• A number	–—	This item appears only when the type is identified as Hard
	between 0		Disk. When Hard Disk is selected, you can change the value.
	and 65,535		This field is changed by incrementing (pressing the [Space-
			bar]) or by typing in the number.
Heads:	• A number	–—	This item appears only when the type is identified as Hard
	between 1		Disk. When Hard Disk is selected, you can change the value.
	and 16		This field is changed by incrementing (pressing the [Space-
			bar]) or by typing in the number.

6