4 | /opt | 0.1 | - |
3.3.2 Work area requirements
None.
3.4 Dynamic Disk Resources
None.
3.5 Memory Requirements
The following table shows the memory required when you use this software for the following operations.
No. | Memory required | Operation |
| (unit:megabytes) |
|
1 | 9 | GigabitEthernet based communication |
*This value shows required memory per a port.In Quad GigabitEthernet card(PW008QG1), about 36 megabytes memory size is required for a card.
3.6 Swap Space
Swap space is not used.
4 Restrictions and Notes
4.1Restrictions
•A JumboFrame function or VLAN interface cannot be used for the private LAN of "SynfinityCluster" and the cluster interconnect of "PRIMECLUSTER".
•VLAN interface cannot be used with "SynfinityLINK" and "PRIMECLUSTER GLS" (But, PRIMECLUSTER GLS 4.1A30 or later only Fast switching mode or NIC switching mode can use VLAN interface.).
4.2Notes
4.2.1 About packages
In case of using on PRIMEPOWER1 or PRIMEPOWER100, please be sure to install the package for PRIMEPOWER1/100 (a procedure is referring to "6. Installation Procedures"). And on other machines, please be sure to install the package for each Solaris OS of use (a procedure is referring to " 6.2 Installing Software "). In addition, the packages for Solaris 8 OS are not able to be installed in Solaris 7 OS.
4.2.2 Using PRIMECLUSTER GLS 4.0 (Multipath Function)
When using PRIMECLUSTER GLS 4.0 (Multipath Function), it is needed
4.2.3 Using PRIMECLUSTER GLS 4.1 (Multipath Function)
When using PRIMECLUSTER GLS 4.1 (Multipath Function), it is needed
4.2.4 Static electrocity (PW008GE5/PW0G8GE2 and PW008QG1)
4.2.5 About VLAN function and LinkAggregation function and Quad GigabitEthernet support
VLAN(Virtual LAN) function can be used in Solaris 8 OS or later.
5