Fujitsu FI-4860C AP-6

AP-6

<Skew error> The following message is displayed, When skewed document is

fed from the hopper to the ADF.

<Hopper is full or

Pick unit not set>

The following message is displayed, when the Pick roller unit is

not set correctly or when there are too many documents.

(When the documents are on the hopper.)

<Pick unit not set> The following message is displayed, when the Pick roller unit is

not set correctly.

(When the documents are not exist on the hopper.)

<Pick unit not set> The following message is displayed, when the Pick roller unit is

not set correctly during scanning.

<Break roller not

set>

The following message is displayed, when scanning while the

Break roller unit is not set correctly.

Irulgr eaprp

Hpreo poervo

otnets

Pcroiklerlu

ni t

Pcroiklerlu

ni t

otnets

Bak

rore

Contents

Main INTRODUCTION i About this manual ii iii Regulatory Information feet) or less. FCC declaration Canadian DOC Regulations Page Page Page vii Trademarks How Trademarks Are Indicated In This Manual viii Note, Liability ix Preface Safety Precautions Warning Indications Used In This Manual x Symbols Used In This Manual R Page Safety Precautions Page Page Page Page Page xviii Fujitsu Group Offices Please send your comments on this manual or on Fujitsu products to the following addresses: xix Page CONTENTS 1 SCANNER BASICS...................................... 1 2 INSTALLATION AND CONNECTIONS .....11 Page Page 2 1.1 Checking the Contents of the Scanner Package 1.2 Names and Functions of Parts 1.2 Names and Functions of Parts This section describes the names of parts and their functions. Units 4 Assemblies Page Function of Buttons 8 Function of LEDs Function of LCD panel Counter display 10 2 CONNECTIONS 12 2.1 Installing the Scanner Cautions on placement of scanner 2.2 Connecting the Scanner Connecting the power cable Connecting the interface cable 14 Page 16 (Back side) Page Page 2.3 Installing the Scanner Driver and Application The flowchart for the Scanner Driver installation 20 Installing FUJITSU TWAIN32 Scanner Driver Page Page Page 24 Page 26 Page 28 When you use Windows95 or WindowsNT4.0 (Please use FUJITSU Page 30 Installing "ScandAll 21" Page Page Page Scanning documents 36 Page 38 AP-1 APPENDIX-1 MESSAGES OF OPERATOR PANEL Massages of Scaner Operation Status AP-2 AP-3 AP-4 Error mesage (Temporary error :Check LED blinking) AP-5 AP-6 AP-7 AP-8 Alarm message (Hardware error :Check LED lighting) AP-9 AP-10 AP-11 AP-12 AP-13 APPENDIX-2 CONSUMABLES AND REPLACEMENT CYCLE AP-14 APPENDIX-3 TROUBLESHOOTING Page AP-16 APPENDIX-4 CLEARING DOCUMENT JAMS CAUTION Removing jams from the hopper or the transport path AP-17 Removing jams from the eject mechanism. Page AP-19 Document separation force adjustment AP-20 Page Page INDEX IN-1 A B C M N O P R fi-4860C Image Scanner Installation Guide