Note: Before scanning your card, test with a dummy card of the same material to see if it can be fed into the ADF properly.
●Cards that are excessively rigid or less flexible may not feed smoothly and excessive noise may occur.
Note: If the cards do not feed smoothly, try:
-Scanning one card at a time.
-Enabling [Automatic Paper Size Detection]. For how to configure this setting, see Section "3.10 Correcting Skewed Documents."
-Raising the resolution.
●Cards should be clean from oil and without labels.
●Cards cannot be scanned when the imprinter is installed.
4.Adjust the side guides to the width of the documents.
Move the side guides so that they touch both sides of the documents. If there is any space between the side guides and the edges of documents, the scanned image may be skewed.
Side guides
HINT
Use of the stacker or stacker extension prevents document sheets from dropping after they are scanned.
Use the stacker and stacker extension as shown in the figure below.
When the document size to scan is A5 or longer in length