Fujitsu FMC-16LX/FR Requirement on Customer Target Board, Schematic Diagram on the Target Board

Requirement on Customer Target Board

In order to connect the adapter cable to the target board, it is required to have the 10-pin standard IDC header on the target board with the connection shown below. Figure 3 shows the connections from the microcontroller to header. For detail pin out refer to Appendix A/B.

47K				SOT/
				SO
				Pyy
		GND
2	4	6	8	10
1	3	10 Pin Header	7	9
		5
SIN/SI				Pxx
MD0				MD2
		470
				+Vcc

Figure 3: Schematic Diagram on the Target Board

Note:

•Pull up and pull down resistor value shown above in MD0 and MD2 line is for reference only. It is recommended to connect the low value of pull up resistor (Approx 470 ohm) to mode pins if required or connect these pins directly to Vcc or Vss directly as per the logic shown in the above diagram. MD1 should be connected to the power supply on the target board, as there is no change in the signal status for normal and flash-programming mode.

•The schematic diagram shown above is for reference only. If necessary, consider the 10-pin header pin out as a top view.

•Pxx and Pyy is the starting pin for programming. Please refer to appendix A and B for more detail about this.

8