4.When the charged battery pack is needed, remove the battery pack from the charger.
When the battery charger is not in use, disconnect the DC power source.
Operational Considerations
Issues to consider when you use the FMW51BC1 battery charger are discussed as follows:
•You can insert up to two battery packs at a time in the battery charger. When charging two battery packs, you can insert or remove either battery pack independently.
•The battery charger only charges one battery pack at a time. When two battery packs are inserted in the charger, the battery pack installed first is charged first.
•The battery charger will indicate a full charge level and will not begin charging the battery pack if the battery pack charge level is 90% or higher when the battery pack is initially inserted in the charger. This prevents the battery pack from being overcharged.
•When you remove the battery pack from your pen tablet, always insert a charged battery pack in the pen tablet to replace the one that you removed, or apply DC power.
•The FMW51BP1, FMW29BP1, FMW29BP2, and FMW43BP2 battery packs use lithium ion battery cells which have no “memory effect.”You do not need to discharge or “condition” the battery pack before charging.
Battery Pack Charge Time
The approximate maximum amount of time needed to charge a fully discharged battery pack to the 90% level is shown in the following table. Note that when two battery packs are installed in the charger, they are charged sequentially (starting with the battery pack that is installed first).
| Battery Pack | Approximate | |
| Charge Time | ||
|
|
| |
|
|
|
|
| FMW51BP1 | <2 hours | |
|
|
|
|
|
| FMW29BP2 | <2 hours |
|
|
|
|
| FMW29BP1 | <3.5 hours | |
|
|
|
|
| FMW43BP2 | <3.5 hours | |
|
|
|
|
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by Fujitsu Personal Systems, Inc., could void the user’s authority to operate the equipment.
2 of 2 |
