14
Stylistic LT P-600 Pen Tablet - Chapter Two
Table 2-1 Changing System States
*Information in Table2-1, “Changing System States,” on page14 is supplied to help you understand
which system states your system can enter from the current system state. Refer to the procedures on
starting the system, shutting down the system, suspending system operation, and resuming system
operation given later in this chapter.
†Your system may be configured to use either Suspend-to-RAM mode or Save-to-Disk mod e.
Powering Up the Pen Ta blet 1
Follow the procedure below to start the Stylistic LT P-600 pen tablet. Before you begin, confirm that
the system is in the Off state. To do so, observe the Status display. If the Power icon is not visible in
the Status display, the system is in the Off state or in Save-to-Disk mode and it is safe to perform this
procedure. If the Power icon is visible (either blinking or on continuously), do not perform this
procedure. See “System States” earlier in this chapter for details on operational modes represented
by the Power icon.
1. Ensure that the battery pack in your pen tablet is sufficiently charged, or connect a n external
power source such as the AC adapter or auto adapter to your pen tablet. See “Status Display” in
Chapter 1 to determine the percentage of charge represented by the Battery Gauge icon in the
Status display.
2. Press the Suspend/Resume button to start the system.
After performing system initialization, the system starts the operating system installed on the hard
disk drive. Once the operating system is running, you can use the system.
Power Icon Appearance Current State To Change State*
Power icon displayed
continuously
On State
or
Idle State
To enter the Off state, shut down the system
using the Start menu on your system.
To enter Suspend-to-RAM or Save-to-Disk†
state, suspend system operation using either a
hardware or software suspend.
Power icon blinking Suspend-to-RAM†
or Standby
To enter the On state, resume system
operation by pressing the Suspend/Resume
button.
To enter the Off state, resume system by
pressing the Suspend/Resume button, then
shut down your system.
Power icon not
displayed
Off State
or
Save-to-Disk†
To enter the On state, start your system, or
resume system operation by pressing the
Suspend/Resume button.
58_0536_00.book Page 14 Wednesday, August 22, 2001 9:07 AM