A d v a n c e d M e n u
Serial/Parallel Port Configuration Submenu of the Advanced Menu
The Serial/Parallel Port Configuration submenu lets you set the I/O addresses and interrupt levels for the serial, infrared and parallel ports of your notebook.
I/O addresses, DMA channels and Interrupt levels can be entered in various ways, including via the BIOS setup utility, the control software for the I/O device, or the hardware. If any two ports or devices, serial or parallel, have the same address assigned, your notebook will not function normally. Keep a record of original settings before making any changes if restoration is required. See your hardware and software documentation as well as the setup utility to determine settings and limitations.
■To prevent IRQ and address conflicts, avoid changing the default settings. If you must change the settings, you can call
■If your notebook emits a series of beeps that sounds like a code and the display is blank, refer to the Troubleshooting Sec- tion in the system User’s Guide. The Troubleshooting Section includes a list of error messages and their meanings.
■All I/O addresses in Table 6 are in hexa- decimal.
|
|
| Phoenix SecureCore(tm) Setup Utility | ||||
| Info | System | Advanced | Security | Boot | Exit | |
|
|
|
|
| |||
|
| Serial/Parallel Port Configurations |
| Item Specific Help |
| ||
|
|
|
|
|
|
|
|
| Serial Port: |
| [Enabled] |
| [Disabled] |
| |
|
|
| The port is disabled. |
| |||
| Base I/O Address/IRQ: | [3F8/IRQ 4] |
|
| |||
|
|
|
| ||||
| Infrared Port: |
| [Enabled] |
| [Enabled] |
| |
| Mode: |
| [FIR] |
|
| ||
|
|
| The port is enabled |
| |||
| Base I/O Address/IRQ: | [2E8/IRQ 3] |
|
| |||
|
| with user configuration. |
| ||||
| DMA Channel: |
| [DMA 3] |
|
| ||
|
|
|
|
| |||
| Parallel Port: |
| [Enabled] |
| [Auto] |
| |
| Mode: |
|
|
| |||
|
|
| Plug & Play OS |
| |||
| Base I/O Address: | [378] |
|
| |||
|
| configure the port. |
| ||||
| Interrupt: |
| [IRQ 7] |
|
| ||
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
F1 Help | Select | Item |
ESC Exit | Select | Menu |
Change | Values | |
Enter | Select | ▲ |
F9 Setup Defaults
F10 Save and Exit
Figure 6. Serial/Parallel Port Configuration Submenu
11
