1. OPERATION
14
1.18.1 Registering a waypoint
Registering a waypoint on the screen
1. Press the MARK key.
The cursor appears along with waypoint
entry instructions. To enter a waypoint to the
current own ship's position, go to step 3.
Cursor
Note: If there is no position data the message
"No position data!" appears. Check the navi-
gator.
2. Press the TrackPad to set the cursor where
desired.
Picture advancement is stopped until step 3
is completed, and the instruction window is
integrated into the data box.
3. Press the MARK or ENTER key to register
the position set at step 2.
A red vertical line appears on the position set
at step 2. The waypoint is named automati-
cally with the next sequential waypoint
number. If you want to change waypoint
name, go to step 4. Otherwise, go to step 6.
Waypoint setting window
Note1: When TLL or FURUNO-TLL is selected
at TLL Output on the NMEA menu of the System
menu, the latitude and longitude position at the
cursor position is output to the navigator.
Note2: If you attempt to enter 21st waypoint, the
message "Already entered 20 waypoints. No
more waypoint can be entered." appears. In this
case, erase an unwanted waypoint to enable
entry. See paragraph 1.18.3 for details.
4. Press the ENTER key to to open the way-
point name entry box.
Waypoint name entry box
5. Enter the waypoint name (Max. 8 charac-
ters).
a) Use S or T to set character. When
pressing S, character order is 0 → 1 → ...
→ 9 → - → A → ... → Z → _ → 0 → ....
When pressing T, character order is
reverse.
b) Use X to shift cursor.
c) Repeat step a) and b) to set the name
desired and press the ENTER key.
6. Press the MENU/ESC key to close the
window.
Registering a waypoint by L/L
1. Press the MENU/ESC key to open the menu.
2. Use S or T to choose Data and press the
ENTER key.
Data menu
Cursor
49.6m
20
40
60
80
0
45.0m 50.0°F
S
/
T
/
W
/
X
: Move cursor
[ENTER] / [MARK] : Set
[MENU] : Cancel
Depth and temperature of cursor position
New Waypoint
Name
: 01
Lat : 34°22.796'N
Lon : 136°07.264'E
Erase?
S
/
T
: Select
[ENTER] : Enter
[MENU] : Quit
01
S
T
Data
S
/
T
/
W
/
X
: Select
[ENTER] : Enter
[MENU] : Bac k
Go to WPT* : Off
WPT List*
Data Box 1
: Off
Data Box 2
: Off
Bearing : True
Wind Spd/Dir : True
Trip Source
: Own
Temp Source
: Own
Speed Source
: Own
Trip Reset
Odo Reset
*: Go to WPT
and WPT
List are
inoperative
when no
latitude and
longitude
position is
input to the
12-24 VDC/
NMEA port.