Furuno FR-8122, FR-8252, Fr8062 CAUTION

1. MOUNTING

1-3

Mounting the antenna unit

The antenna unit can be mounted using the fixing holes on the outside (200x200 mm) or

inside (140x150 mm) the antenna unit.

Using outside fixing holes of the antenna housing

Use the hex head bolts (supplied) to mount the antenna unit as below.

1. Lay the corrosion-proof rubber mat (supplied) on the mounting platform.

Rubber

mat

Location of r ubber mat

2. Lay the antenna unit on the mounting platform, orienting it as shown in below.

STERN

BOW

Antenna unit

CAUTION

Do not lift the Antenna unit by the

radiator; lift it by the housing.

The radiator may be damaged.

Contents

Main Page i WARNING Radio Frequency Radiation Hazard SAFETY INSTRUCTIONS WARNING CAUTION ii TABLE OF CONTENTS iii SYSTEM CONFIGURATIONS FR-8062/8122 Category of units Antenna unit: Exposed to weather All other units: Protected from weather i v FR-8252 ANTENNA UNIT RSB-0073-087-XN12A/XN13A EQUIPMENT LISTS *: See lists on the back of this manual. Standard Supply vi Optional Supply 1-1 1. MOUNTING 1.1 Antenna Unit Mounting considerations 1-2 Mounting procedure 1-3 STERN CAUTION 1-4 1-5 8. Coat ground terminal and ground point with silicone sealant as shown below. OR Hex nut How to coat ground point and ground termi nal with sili cone s ealant 1-6 1-7 Remove shrink tubing. 2. Remove vinyl sheath approx. 50 mm. Cut vinyl sheath approx. 50 mm. Braided shield Vinyl sheath 1-8 1-9 1-10 1-11 . 1-12 1.2 Display Unit Mounting considerations 1-13 Mounting procedure 1-14 1-15 1.3 Power Supply Unit Page 2-1 2. WIRING 2.1 Standard Wiring 2. WIRING 2-2 2.2 Wiring the Power Supply Unit Cabling 2-3 Jumper block, slide switch setting Power requirement, replacement of fuses 2-4 2.3 Port for External Devices 3-1 3. SETTING UP THE EQUIPMENT 3.1 Setting Language 3-2 3.2 Opening the Installation Menu Basic Settings 3-3 Heading Adjustment 3-4 S S 0 (0 359 ) Auto Installation Setup Tuning Initial Adjust 3-5 Manual Timing Adjust 3-6 Manual MBS Adjust Video Initial Adjust 4-1 4. OPTIONAL EQUIPMENT 4.1 ARP Kit ARP-11 Page 4-3 4.2 External Monitor 4-4 4-5 4.3 Remote Display Page 4-7 4.4 External Buzzer Page RDP-150-J/E A-1 #-: 0#/' 176.+0' &'5%4+26+10%1&' 36; -4 -5 %2 %2 )6: -6 -7 %2 )6: )6: