Furuno FR-8122, FR-8252, Fr8062 , 1-8

1. MOUNTING

1-8

• Connecting the signal cable

1. Open the antenna cover by loosening four bolts, and then fix the stay.

Cable entry RTB board cover

Antenna unit c has s is, cover opened

2. Unfasten the cable gland assembly (plate, gasket, flat washer). The plate may be

discarded.

3. Pass the signal cable with connector through the bottom of the antenna unit chassis.

Pass the cable through the gland assembly as shown below.

Gasket support

Gasket

Flat washer

Cable entry

Passing the si gnal c able thr ough the cab le gland assembly

4. Fasten the gasket support with four bolts. Using one of the four bolts, fasten the

crimp-on lug to the shield wire.

Contents

Main Page i WARNING Radio Frequency Radiation Hazard SAFETY INSTRUCTIONS WARNING CAUTION ii TABLE OF CONTENTS iii SYSTEM CONFIGURATIONS FR-8062/8122 Category of units Antenna unit: Exposed to weather All other units: Protected from weather i v FR-8252 ANTENNA UNIT RSB-0073-087-XN12A/XN13A EQUIPMENT LISTS *: See lists on the back of this manual. Standard Supply vi Optional Supply 1-1 1. MOUNTING 1.1 Antenna Unit Mounting considerations 1-2 Mounting procedure 1-3 STERN CAUTION 1-4 1-5 8. Coat ground terminal and ground point with silicone sealant as shown below. OR Hex nut How to coat ground point and ground termi nal with sili cone s ealant 1-6 1-7 Remove shrink tubing. 2. Remove vinyl sheath approx. 50 mm. Cut vinyl sheath approx. 50 mm. Braided shield Vinyl sheath 1-8 1-9 1-10 1-11 . 1-12 1.2 Display Unit Mounting considerations 1-13 Mounting procedure 1-14 1-15 1.3 Power Supply Unit Page 2-1 2. WIRING 2.1 Standard Wiring 2. WIRING 2-2 2.2 Wiring the Power Supply Unit Cabling 2-3 Jumper block, slide switch setting Power requirement, replacement of fuses 2-4 2.3 Port for External Devices 3-1 3. SETTING UP THE EQUIPMENT 3.1 Setting Language 3-2 3.2 Opening the Installation Menu Basic Settings 3-3 Heading Adjustment 3-4 S S 0 (0 359 ) Auto Installation Setup Tuning Initial Adjust 3-5 Manual Timing Adjust 3-6 Manual MBS Adjust Video Initial Adjust 4-1 4. OPTIONAL EQUIPMENT 4.1 ARP Kit ARP-11 Page 4-3 4.2 External Monitor 4-4 4-5 4.3 Remote Display Page 4-7 4.4 External Buzzer Page RDP-150-J/E A-1 #-: 0#/' 176.+0' &'5%4+26+10%1&' 36; -4 -5 %2 %2 )6: -6 -7 %2 )6: )6: