Furuno FR-8122, FR-8252, Fr8062 4.4 External Buzzer

4. OPTIONAL EQUIPMENT

4-7

4.4 External Buzzer

The optional external buzzer provides a louder alert when an alarm is violated.

External buzzer

Type: OP03-136

Code no.: 000-086-443

Further, you need the optional cable assy. MJ-A7SPF0007-050C (w/7P connector, 5 m,

code no. 000-154-028-10).

1. Attach the MJ-A7SPF0007-050C cable assy. (option) to the PC/EXT-BUZZER port at the

rear of the display unit.

2. Cut off the XH connector and cable itself (as necessary) at the end of the external

buzzer cable.

3. Solder the cables made at step 2 to the MJ-A7SPF0007-050C cable as shown below.

Red

Black

External buzzer MJ-A7SPF0007-050C

Soldering

Other wires should be cut off,

and wrap here with vinyl tape.

Connec tion of external buzzer and display unit

usi ng c able assy. type MJ-A7SPF 0007- 050C cable

4. Attach the buzzer to the mounting location with double-sided tape or two self-tapping

screws (3x15 or 3x20, local supply).

Contents

Main Page i WARNING Radio Frequency Radiation Hazard SAFETY INSTRUCTIONS WARNING CAUTION ii TABLE OF CONTENTS iii SYSTEM CONFIGURATIONS FR-8062/8122 Category of units Antenna unit: Exposed to weather All other units: Protected from weather i v FR-8252 ANTENNA UNIT RSB-0073-087-XN12A/XN13A EQUIPMENT LISTS *: See lists on the back of this manual. Standard Supply vi Optional Supply 1-1 1. MOUNTING 1.1 Antenna Unit Mounting considerations 1-2 Mounting procedure 1-3 STERN CAUTION 1-4 1-5 8. Coat ground terminal and ground point with silicone sealant as shown below. OR Hex nut How to coat ground point and ground termi nal with sili cone s ealant 1-6 1-7 Remove shrink tubing. 2. Remove vinyl sheath approx. 50 mm. Cut vinyl sheath approx. 50 mm. Braided shield Vinyl sheath 1-8 1-9 1-10 1-11 . 1-12 1.2 Display Unit Mounting considerations 1-13 Mounting procedure 1-14 1-15 1.3 Power Supply Unit Page 2-1 2. WIRING 2.1 Standard Wiring 2. WIRING 2-2 2.2 Wiring the Power Supply Unit Cabling 2-3 Jumper block, slide switch setting Power requirement, replacement of fuses 2-4 2.3 Port for External Devices 3-1 3. SETTING UP THE EQUIPMENT 3.1 Setting Language 3-2 3.2 Opening the Installation Menu Basic Settings 3-3 Heading Adjustment 3-4 S S 0 (0 359 ) Auto Installation Setup Tuning Initial Adjust 3-5 Manual Timing Adjust 3-6 Manual MBS Adjust Video Initial Adjust 4-1 4. OPTIONAL EQUIPMENT 4.1 ARP Kit ARP-11 Page 4-3 4.2 External Monitor 4-4 4-5 4.3 Remote Display Page 4-7 4.4 External Buzzer Page RDP-150-J/E A-1 #-: 0#/' 176.+0' &'5%4+26+10%1&' 36; -4 -5 %2 %2 )6: -6 -7 %2 )6: )6: