INSTALLATION GUIDE
1.Check mounting position for adequate space (see caution)
2.Place the mounting bracket in position, then mark and drill mounting holes.
3.Place the mounting bracket and affix with supplied screws.
4.Connect the wires from the source unit to the cabin speaker ensuring the correct polarity is observed.
5.Attach the cabin speaker to the bracket using the washers and mounting knobs supplied.
6.Adjust the angle of the speaker to the preferred position before tightening the mounting knobs.
CAUTION: For speaker mounting restrictions related to Magnetic interference, please refer to the manufacturers recommendations for any navigational equipment.
INSTALLATION TIPS
Any speaker will only perform to its best capabilities, when correctly placed in the listening area. FUSION Engineers recognise that unlike a home or motor vehicle installation, there are an extremely wide range of marine environments where speakers may be placed.
FUSION
•High frequencies are directional. Placing the speakers low down in the boat will lose some of its information.
•Speakers should be placed to simulate a “sound stage”, by being placed where you are able to hear both speakers in a stereo situation.
TROUBLESHOOTING
Before you contact your FUSION dealer or service centre, FUSION requires that you do some simple troubleshooting to help diagnose or resolve the problem.
PROBLEM | SOLUTION |
No Sound | Check all connections from the source unit |
| amplifier to the speaker terminals are |
| connected correctly. |
System lacks in bass | Check the connections from the source |
| unit/amplifier to the speaker. Check Polarity. |
System lacks in |
|
high frequencies: | Check Polarity |
| Check the bass / treble control settings on the |
| source unit. |
Distorted sound | Check all wiring |
| Check that it is not the surrounding panels of |
| the craft rattling. Check connections from the |
| source to the speaker. |
4 | 5 |