To test the transom mount transducer installation:

1.Begin testing the installation at a slow speed. If the sonar appears to be working properly, gradually increase the speed of the boat while observing the operation of the sonar. If the sonar signal suddenly is lost or the bottom return is severely degraded, note the speed at which this occurs.

2.Return the boat to the speed at which the signal was lost. Make moderate turns in both directions to see if the signal improves.

3.If the signal strength improves while turning, adjust the transducer so that it extends another 1/8 in. below the transom of the boat. It might take several adjustments to eliminate the degradation.

4.If the signal does not improve, you might have to move the transducer to a different location.

Caution: When adjusting the depth of the transducer, make the adjustments in small increments. Placing the transducer too deep can adversely affect the performance of the boat and put the transducer at greater risk of striking underwater objects.

Specifications

Physical Specifications

Size : 400 Series: W × H × D: 5.7 × 5.0 . × 3.0 in. (14.5 × 12.7 × 7.6 cm)

500 Series: W × H × D: 5.9 × 6.4 × 2.9 in. (15.0 × 16.3 × 7.4 cm)

Weight: 400 Series: 1.30 lb. (560 g) 500 Series: 1.75 lb. (800 g)

Display: GPSMAP 420/421/430/431/440/441/450/451 (s): 4.0 in.

diagonal (10.6 cm), QVGA display with adjustable brightness, 320 × 240 pixels.

GPSMAP 520/521/530/531/540/541/550/551 (s): 5.0 in. diagonal (12.7 cm), QVGA display with adjustable brightness, 320 × 234 pixels.

GPSMAP 525/526/535/536/545/546/555/556 (s): 5.0 in. diagonal (12.7 cm), Full VGA display with adjustable brightness, 640 × 480 pixels.

Case: Fully gasketed, high-impact plastic alloy, waterproof to IEC 529 IPX7 standards.

Temp. Range: From 5ºF to 131ºF (from -15ºC to 55ºC)

Compass-Safe Distances:

Model Number

Compass-Safe

 

Distance

GPSMAP 526/536/546/556

24 in. (60 cm)

GPSMAP 421/431/441/451

26 in. (65 cm)

GPSMAP 521/531/541/551

30 in. (75 cm)

GPSMAP 420/430/440/450

38 in. (95 cm)

GPSMAP 520/530/540/550/525/535/545/555

 

Performance

Receiver:

GPSMAP 420/430/440/450 (s)

GPSMAP 520/530/540/550/525/535/545/555 (s): Differential-ready 12 parallel channel WAAS-capable receiver

GPSMAP 421/431/441/451 (s)

GPSMAP 521/531/541/551 (s):

High-sensitivity 14 parallel channel WAAS-capable receiver.

GPSMAP 526/536/546/556 (s):

High-sensitivity 12 parallel channel WAAS-capable receiver.

Acquisition Times: (Average acquisition times for a stationary receiver with a clear view of the sky.)

GPSMAP 420/430/440/450 (s)

GPSMAP 520/530/540/550/525/535/545/555 (s): Warm*: Approximately 15 seconds

Cold**: Approximately 45 seconds

GPSMAP 421/431/441/451 (s)

GPSMAP 521/526/531/536/541/546/551/556 (s): Warm*: Approximately 1 second

Cold**: Approximately 38 seconds

*Warm: your unit is at or near the last location where you recently acquired satellites.

**Cold: your unit has moved by more than about 500 mi. (800 km) since it was turned off.

Update Rate: 1/second, continuous

GPS Accuracy:

Position: <49 ft. (15 m), 95% typical

Velocity: 0.164 ft./sec 0.05 m/sec steady state

WAAS Accuracy:

Position: <10 ft. (3 m), 95% typical

Velocity: 0.05 m/sec steady state

Dynamics: 6 g

Power

Power Source: 10–32 Vdc GPSMAP 421/431/441/451 (s)

GPSMAP 521/531/541/551/526/536/546/556 (s)

Power Source: 10–35 Vdc

GPSMAP 420/430/440/450 (s)

GPSMAP 520/530/540/550/525/535/545/555 (s) Usage: 15 W max at 13.8 Vdc

Fuse: AGC/3AG - 3.0 A

10

GPSMAP 400/500 Series Installation Instructions