Garmin 90/140 INSTALLING YOUR FISHFINDER, Packing List (one of each, unless otherwise noted):

INSTALLING YOUR FISHFINDER > PACKING LIST

INSTALLING YOUR FISHFINDER

Make sure you completely read and understand all instructions before you install and use your Fishﬁnder. If you have problems, contact Garmin Product Support, or seek other professional assistance.

You can install the Fishﬁnder hardware on a transom or on a trolling motor. Before installation, make sure the wiring harness can reach the Fishﬁnder and transducer locations.

Check the packing list below. If you are missing any items, contact your Garmin dealer.

(Fishﬁnder 90)

B1	D

(Fishﬁnder 140)

CB2

(Fishﬁnder 90)

Packing List (one of each, unless otherwise noted):

A—Fishﬁnder sonar unit	I—Trolling motor mount gasket
B1—Swivel mount bracket (Fishﬁnder	J—5 mm Flat washers (2)
140; optional for Fishﬁnder 90); or	K—5 x 30 mm Screws (2)
B2—Tilt mount bracket (Fishﬁnder 90)	L—10-32 Lock nut
C—Swivel base (Fishﬁnder 140)	M—4 x 12 mm Screws (4)
D—Mounting knobs	N—10-32 x 1.75 Screw
E—Mounting knob spacer	O—1/4" Cable clamps (2)
F—Snap ring	P—Plastic spacer
G—Transducer with power cable	Q—1/4" Rubber washer
H—Transducer mount	R—Cable tie, 5.6" (4)
Fishﬁnder 90/140 Owner’s Manual	S—Cable tie, 20”
Fishﬁnder 90/140 Owner’s Manual

		(Cable not shown)
	J	N
	K	N
	K
	L	O
	M	O
	M