Final Wiring Connections

Once the scanner is installed and the cable routed, you are ready to connect the Power and Marine Network.

1.Connect the Black Ground (-) wire to the vessel’s negative power terminal.

2.Connect the Power (+) wire (with fuse holder) to the vessel’s positive power terminal.

3.For a stand-alone network (MFD and Radar only), attach the RJ-45 Marine Network Cable to the RJ-45 socket on the back of the MFD. For an expanded network (MFD, Radar, GMS 10, etc.) attach, the RJ-45 Marine Network Cable to an open RJ-45 socket on the GMS 10 Network Power Expander. Tighten the RJ-45 locking ring clockwise until it is firmly sealed.

GPS 17

GMR 20/40 MARINE

 

RADAR

GARMIN

GPSMAP MFD

Stand Alone Network

GARMIN GMS 10

GA 31

GARMIN GDL 30/30A

MARINEWEATHER/AUDIO

SATELLITE RECEIVER

GMR 20/40 MARINEMARINE NETWORK PORT EXPANDER RADAR

GPS 17

GARMIN

GARMIN

GPSMAP MFD

GPSMAP MFD

 

GSD 20 TOTRANSDUCER

SOUNDER

MODULE

Expanded Network

GMR 20/40 Radar Installation Manual

4