1)This STC supports interface with the MX20, but does not support the installation of the MX20. See paragraph 3.2 Prerequisite.
3.GENERAL INSTALLATION REQUIREMENTS
3.1General
The installation must be done in accordance with all applicable FARs. The installation shall conform to the data listed in Section 2.1, Data Required for Installation with exception of special instructions as defined in Section 4 Special Installation Instructions, which shall have precedence over the data listed in Section 2.1.
3.2 Prerequisite
This GWX 68 STC supports interface with the MX20 multifunction display unit. It does not support installation of the interfaced equipment. This STC requires previous or concurrent installation of the MX20 multifunction display installed under STC SA02154AK or other approved installation.
3.3 Mechanical
Mechanical installation, wiring, cable bundling and routing, and connections to existing aircraft systems must conform to those specific instructions or requirements found in the STC data. Those aspects of the STC where specific installation instructions or requirements are not provided in the STC data, the installer shall conform to the recommended practices and procedures found in AC
3.4 Hardware
Hardware not supplied with the equipment, or otherwise specified in the appropriate installation manuals or other STC data (ie screws, nuts, tie wrap…. etc) shall be from standard aircraft hardware as described
by AC
3.5 Wiring
All wire used in the installation shall be of appropriate standard aircraft quality grade and size as described in AC
3.6 Circuit Protection
All GWX 68 modification circuits shall be protected in accordance with AC
3.7 Electrical Load Analysis
An electrical load analysis shall be performed on each aircraft, as described in AC
GWX 68 Weather Radar Installed in Beech Queen Air/King Air Series | |
STC Master Data List | Page 5 |