Start Here
2 Lower the output tray, then open the extension.
3 Flip the feeder guard forward.
4 Squeeze the edge guide and slide it to the left.
5 Load paper against the right edge guide and behind the
tab, with the printable side face up.
4 x 6
8½ x 11
Read these instructions before using your printer.
1 Unpack
Power cord
Epson Stylus NX125/127
Series
Quick Guide
Basic Copying, Printing, and Scanning
Maintenance
Solving Problems
®
Caution: Do not open the ink cartridge package until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2 Turn on
1 Connect the power cable.
Caution: Do not connect to your computer yet.
2 Press the power button.
3 Install ink cartridges
1 Open the document cover, then open the ink cover.
Caution: Don’t try to remove the ink cartridge guard or you may
damage the printer.
2 Shake the ink cartridges, then unpack them.
3 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals from the cartridges.
4 Insert the cyan ink cartridge, and press it down until it clicks.
5 Press the stop button. The cartridge holder moves.
6 Repeat steps 4 and 5 for other cartridges.
7 Close the ink cover, then close the document cover and
press the stop button again.
8 Ink priming takes about 2 minutes. When the green power
light stops blinking, priming is complete.
Note: Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
Caution: Don’t turn off the printer while it is priming or you’ll
waste ink.
4 Load paper
1 Open the paper support, then pull up the extension and tilt
it back slightly.

Epson Stylus® NX125/127 Series

4119074 Rev.0
1-F C
4119074 Rev.0
1-F M
4119074 Rev.0
1-F Y
4119074 Rev.0
1-F K