DRAWING 5 - Setup for SW203 and SW303
NOTE:
SEE ITEM 4 ABOVE FOR
PROPER RECEIVER
TYPE SWITCH SETTING
D

SUBWOOFER

CONNECTION

See Drawings 4 and 5
Note: Use the RCA to RCA connector cable
that was supplied with the speaker system.
IMPORTANT:Make sure that ALL
stereo system components including
the SW103/SW203/SW303 are turned
OFF before proceeding.
o1. Locate the subwoofer output connect-
or on the rear of your receiver and connect
one end of the RCA line level cord to it.
o2. Route the line cord to the subwoofer
location (trying to minimize areas where it
may be stepped on) and connect the other
end directly to the SUB IN.
o3. Connect your main (and surround
speakers if applicable) to the receiver
according to the receiver’s owner’s manual.
o4. For the SW203 and SW303, set the
RECEIVER TYPE toggle switch to receiver
mode you will be using. Note: If you are
using a Dolby Digital type receiver, the sub-
woofer crossover control does not work.
You must set the crossover frequency in
your receiver (check the receiver’s owner’s
manual).
o5. You are now ready to put your
SW103/SW203/SW303 subwoofer into use.
6
DRAWING 4 - Setup for SW103
SURROUND SOUND RECEIVER
SURROUND SOUND RECEIVER
SW303 connection
SW203 connection