GE 00024178 Remote Access

34

Remote Access

You can access your answerer from any touch-tone phone from another location

by entering your 3-digit security code (the default security code is 1 2 3, but you can

change it.) Be aware that remote functions do not work with rotary or push-button

pulse-dialing phones.

To access your answerer:

1. Call your telephone number.

2. After you hear the beep that follows the greeting, enter your 3-digit security code.

The unit conrms your code with a beep. To bypass the greeting, you can enter

your 3-digit security code any time while the greeting is playing.

The unit waits for a remote command for 20 seconds after the correct security code

has been entered. Menu selections can be made while the menu is playing.

NOTE: The unit answers on the 10th ring when it is turned off or the

memory is full. To access the answerer, enter the 3-digit security

code after the beep. If memory is full, play messages and erase

some of them to restore memory.

NOTE: After the unit plays the remote menu, it waits 20 seconds for

a command, then disconnects.

Remote Access Commands

Play messages 2

Repeat messages (during message playback) 1

Skip to next message (during message playback) 3

Erase message (during message playback) 0

Stop playback(during message playback) 2

Turn answerer On/Off 4

Review menu again 7

Contents

Main Equipment Approval Information Interference Information Hearing Aid Compatibility Licensing FCC RF Radiation Exposure Statement Page Table of Contents Telephone Jack Requirements Introduction Before You Begin Parts Checklist Page Base Layout Installing the Phone Desktop Installation Wall Mounting the Phone Important Instructions for Moving the Answerer: Answering System Setup Recording the Outgoing Announcement Reviewing the Announcement Telephone Operation Using the Speakerphone Speakerphone Location Speakerphone Use Receiving a Phone Call Placing a Phone Call Switching between Speaker and Handset Temporary Tone Dialing Page Telephone Set Up Setting the Rings to Answer Toll Saver Setting the Incoming Message or Memo Length Setting the Recording Quality Setting the Security Code Setting the Display Contrast Setting Your Local Area Code Setting the Dialing Mode Setting Day of Week Setting the Time and Date Hour Minutes AM/PM Month Setting the Language Message Volume Ringer Volume Page Caller ID Features Summary Screen Caller ID with Call Waiting Receiving and Storing Calls Reviewing Call Records Deleting CID Records Dialing Back If You Programmed Your Local Area Code If You Did Not Program Your Local Area Code Memory Storing a Number in Memory Storing a Redial Number to Memory Erasing a Stored Number Copying Caller ID Memories to User Memory Page Reviewing Stored Numbers Chain Dialing from Memory Answering System Operation Call Answering Auto Disconnect Playing Messages Erase Messages Leaving a Memo Memory Full Remote Access Remote Access Commands Message Indicators Troubleshooting Guide Page Page General Product Care Causes of Poor Reception Warranty Assistance Limited Warranty Page Page Index P R S T Visit our website at: www.GE.com/phones